CONREVSMA004

REVISIONS REV DESCRIPTION A INITIAL RELEASE OF LINX INTERNAL DRAWING DATE APPV 01/MAR/19 CLL HEX 8.00 0.315 FLAT 5.80 0.228 1/4-36UNS-2A THREADS 9.24 0.364 2.75 0.108 5.80 0.228 1.30 0.051 17.30 0.681 1.60 0.063 HEX 8.0 10.20 0.402 9.90 0.390 NOTES: (UNLESS OTHERWISE SPECIFIED) 1. ALL DIMENSIONS ARE IN mm [INCHES]. 2. DIMENSIONS APPLY AFTER FINISHING. 3. MANUFACTURE TO BE COMPLIANT WITH EU RoHS DIRECTIVE, USE MATERIALS THAT DO NOT CONTAIN REACH SUBSTANCES OF VERY HIGH CONCERN >1000ppm, AND USE DRC CONFLICT-FREE SOURCED MATERIALS. 4. SAFETY BREAK ALL SHARP CORNERS AND EDGES 0.5 MAXIMUM. 5 SEE TABLE I FOR ELECTRICAL SPECIFICATIONS. (SHEET 2) 0.50 6 SEE TABLE II FOR ENVIRONMENTAL SPECIFICATIONS. (SHEET 2) 0.020 7 SEE TABLE III FOR MECHANICAL SPECIFICATIONS. (SHEET 2) 8. SEE PARTSLIST. "*" INDICATES FINISH TYPE. WARNING: THIS DRAWING CONTAINS PROPRIETARY INFORMATION 159 ORT LANE THAT IS THE SOLE PROPERTY OF LINX TECHNOLOGIES, AND SHALL BE MERLIN, OR 97532 TREATED AS SUCH. NO DISCLOSURE OR REPRODUCTION OF THIS DOCUMENT IS PERMITTED, IN WHOLE OR IN PART, WITHOUT THE EXPRESS WRITTEN PERMISSION OF LINX TECHNOLOGIES OR ITS DESIGNATED AGENTS. MATERIAL: SCALE 1 : 1 NUT WASHER 1.24 0.049 FINISH: TOLERANCES: 0.50 [.020]-5.00 [.200]= 0.20 [.008] 5.00 [.200]-30.00 [1.200]= 0.40 [.016] 30.0 [1.20]-120.0 [4.75]= 0.60 [0.24] 120.0 [4.75]-315.0 [12.40]= 1.0 [.040] DRAWN: M. SCHULTE PROJECTION: ANGLES: 1 DT: 21/JAN/19 ENGR: D. VARATHARAJAN DT: 08/MAR/19 TITLE: RP-SMA FEMALE BULKHEAD FRONT MOUNT W/SOLDER POT SIZE DWG. NO. A REV CONREVSMA004-* SCALE: 4:1 DO NOT SCALE DRAWING A SHEET 1 OF 2 LDCFDAL_C 5 SEE SHEET 1 FOR REVISIONS TABLE I 6.00 0.236 6 TABLE II 6.50 0.256 RECOMMENDED MOUNTING HOLE 7 TABLE III SIZE DWG. NO. A REV CONREVSMA004-* SCALE: 1:1 DO NOT SCALE DRAWING A SHEET 2 OF 2 LDCFDAL_A