NRF6703

Getting Started Guide Flash/OTP Programming Adapter Kit nRF6701 nRF6702 nRF6703 nRF6704 1. Register at www.nordicsemi.com and download all kit software and documentation 1. 2. 3. 4. 5. 6. Go to www.nordicsemi.com. Log in to your MyPage account (or create an account first if you don’t already have one). Select My Products from the left menu. From the Add Product list, select nRF24LE1 Programming Kit. Click Add. Click the Downloads link in the Overview, My Products table. Available documentation and software are listed on the Downloads tab. 7. Below Software click nRFgo Studio and run the install file. 8. The software will be available from your Windows Start menu. 2. Plug in the Flash/OTP Programming Adapter Module Plug the Flash/OTP programming adapter module into the Extension Board slots EXT A and EXT B on an nRFgo Starter Kit Motherboard (sold separately).  Note: No nRFgo module can be plugged into the nRFgo Starter Kit Motherboard’s nRF Module slots MOD A and MOD B. 3. Connect the nRFgo Starter Kit Motherboard to a PC Connect the nRFgo Starter Kit Motherboard to an available USB port on your PC using a USB cable. 4. Power On 1. Turn the S8 switch on the nRFgo Starter Kit Motherboard to VBUS. 2. Turn the S9 switch on the nRFgo Starter Kit Motherboard to On. The VTG and VCC LEDs will light up green. 5. Start nRFgo Studio www.leoxpress.no 1. From the Windows Start menu on your computer go to All Programs – Nordic Semiconductor – nRFgo Studio and open nRFgo Studio.exe. 2. The connected nRFgo Flash/OTP programming adapter module is found at Board 0 -> in the nRFgo Studio Device Manager. Make sure the checkbox ”Device is OTP” is selected if an OTP device is being programmed.