AOCJY5

OVEN CONTROLLED CRYSTAL OSCILLATOR OVEN CONTROLLED CRYSTAL OSCILLATOR AOCJY5 Series FEATURES: Pb RoHS Compliant 36.1x 27.2 x 13mm |||||||||| ||||| APPLICATIONS: • 36.1x 27.2 x 13mm Leaded- RoHS Compliant Reflow-able Package • COTS Military & Industrial Radios & Timing Circuits • SC-Cut, High “Q” resonator based design • Cellular Infrastructure • Radar Systems • Sinewave output into 50Ω • Test & Measurement Equipment • Available with ± 50 ppb accuracy over -55°C to +85°C temperature range • GPS Tracking with precision hold-over accuracy • Exceptional long-term Aging of ±500 ppb max. over 10-Year Product Life • Excellent close-in phase noise (-145 dBc/Hz Typical @1kHz offset; 10MHz carrier) • WiMax / WLAN STANDARD SPECIFICATIONS: Parameters RF Output Frequency Standard Available Frequencies Waveform Peak Power Output Load Short Term Stability Operating Temperature Range Frequency Stability -55º C to +85ºC As received frequency @ 25°C ±3°C Frequency Stability vs. Supply Voltage (Vdd ± 5%) Frequency Stability vs. Load Variation (± 10%) Warm-Up @ 25 ºC Power Consumption @ turn on Power Consumption Steady State Power Consumption Steady State Supply Voltage (Vdd) Storage Temperature Range Aging Daily First Year 10-Years Spectral Content Spurious Response Harmonics ±50.00 ±100.00 ±1.00 ±1.00 ±100.00 6.00 2.00 5.00 12.60 +100 ±1.0 ±100 ±500 -70 -30 ppb ppb ppb ppb ppb Watts Watts Watts Volts ºC ppb ppb ppb dBc dBc In < 3-minutes Over operating temperature range @ 25°C ±3°C Over operating temperature range (-55°C to +85°C) @ Vc=2.50Volts -55 Minimum Typical 10.00 10.00 MHz Sinewave 7.00 50 -10 1x10 +85 Maximum Units MHz Notes dBm Ω /second ºC Alan Variance 11.40 -55 12.00 ABRACON IS ABRACON IS ISO9001:2008 CE RTIFIED CE RTIFIED Visit www.abracon.com for Terms & Conditions of Sale Revised: 07.24.11 30332 E speranza, Rancho Santa Margarita, California 92688 tel 949-546-8000 | fax 949-546-8001 | www.abracon.com OVEN CONTROLLED CRYSTAL OSCILLATOR AOCJY5 Series Pb RoHS Compliant Minimum Typical Maximum -90 -120 -140 -145 -150 -152 0.0 ±0.500 Positive 100 2.40 4.90 -40 2.50 5.00 2.60 ±10 5.10 +100 kΩ Volts % Volts ºC 5.00 Units dBc dBc dBc dBc dBc dBc Volts ppm 36.1x 27.2 x 13mm ||||||||||| ||| STANDARD SPECIFICATIONS - continued. Parameters Phase Noise (10MHz Carrier) @ 12V @1 Hz offset @ 10 Hz offset @ 100 Hz offset @ 1,000 Hz offset @ 10,000 Hz offset @ 100,000 Hz offset Electrical Frequency Adjustment Control Voltage Range (Vc) Frequency Pull Range Frequency Pull Slope Control Voltage Port Impedance Center Control Voltage Control Port Linearity Reference Voltage (Vdd=12.0V) Storage Temperature Notes Output @ Pin#2 TYPICAL PHASE NOISE PERFORMANCE @ 10MHZ CARRIER OPTIONS AND PART IDENTIFICATION (Left blank if standard) AOCJY5 Frequency in MHz Such as; 10.000 MHz MHz By default, AOCJY5 OCXO is constructed with the following key specifications: i) ii) iii) Supply Voltage Operating Temperature Range RF Output = = = 12.00 Volts -55°C to +85°C Pure Sinewave into 50Ω ABRACON IS ABRACON IS ISO9001:2008 CE RTIFIED CE RTIFIED Visit www.abracon.com for Terms & Conditions of Sale Revised: 07.24.11 30332 Esperanza, Rancho Santa Margarita, California 92688 tel 949-546-8000 | fax 949-546-8001 | www.abracon.com OVEN CONTROLLED CRYSTAL OSCILLATOR AOCJY5 Series OUTLINE DIMENSIONS Pb RoHS Compliant 36.1x 27.2 x 13mm ||||||||||||||| 12 PACKAGING: pcs/tray REFLOW PROFILE: TS max to T L (Ramp-up Rate) Preheat Temperature Min. (T Temperature Max. (T Time (t S ) Ramp-up rate (T --Temperature (T L S 3°C/second max. 150°C 175°C 200°C 60 ~ 180 seconds 3°C/second max. Min.) S Temperature Typical (T S Typ.) Max.) to T p ) (T L) p Time Maintained Above: L)/Time p) 217°C/60 ~ 150 seconds 250°C max. for 10 seconds Target) p) Peak Temperature (T Target Peak Temperature (T Ramp-down Rate 250°C +0/-5°C 20 ~ 40 seconds 6°C/second max. 8 minutes max. Time within 5°C of actual peak (t Tune 25°C to Peak Temperature (t) ATTENTION: Abracon Corporation’s products are COTS – Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications. Abracon’s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where component failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and authorization from Abracon Corporation is required. Please contact Abracon Corporation for more information. ABRACON IS ISO9001:2008 CE RTIFIED CE RTIFIED Revised: 07.24.11 30332 Esperanza, Rancho Santa Margarita, California 92688 tel 949-546-8000 | fax 949-546-8001 | www.abracon.com Visit www.abracon.com for Terms & Conditions of Sale