VSC3340YJJ-31

VSC3340-31 3.5 Gbps 40 × 40 Crosspoint Switch Microsemi’s multichannel 3.5 Gbps crosspoint switch provides a cost-effective solution for high-speed copper interconnects. Highlights The VSC3340-31 is an advanced signal conditioning crosspoint switch solution uniquely capable of addressing a wide array of asynchronous, physical layer switching, and routing applications across storage, server, video, communications, and other industries. Featuring a 40 × 40 non-blocking, multicasting switch core with ports running at any rate up to 3.5 Gbps, the VSC3340-31 architecture provides protocol-transparent operation, allowing each channel to run independently. VSC3340-31 supports virtually all standard and proprietary data protocols up to the maximum data rate. • 40 × 40 fully non-blocking switch capability • DC to 3.5 Gbps operation • Protocol-independent operation • Advanced input equalization and output preemphasis • Small 23 mm × 23 mm form factor Applications • Servers • Storage • HDMI/DVI/DisplayPort switching/routing The device incorporates Microsemi’s fourth-generation input equalization and pre-emphasis I/O capability engineered to overcome channel impairments experienced in today’s high-density systems at multi-gigabit data rates. It can perform signal fanout, loopback, and protection switching. It can also regenerate signals compromised by losses in the transmission medium. Microsemi’s equalization provides highly effective compensation for deterministic jitter across a wide range of high-speed interconnect applications. • Broadcast video switching/routing VSC3340-31 Line Card and Central Switch Card Applications Line Card Module Serial DC to 3.5 Gbps PHY ASIC or FPGA 40 Serial DC to 3.5 Gbps VSC3340-31 40 Backplane Switch Card VSC3340-31 Microsemi makes no warranty, representation, or guarantee regarding the information contained herein or the suitability of its products and services for any particular purpose, nor does Microsemi assume any liability whatsoever arising out of the application or use of any product or circuit. The products sold hereunder and any other products sold by Microsemi have been subject to limited testing and should not be used in conjunction with mission-critical equipment or applications. Any performance specifications are believed to be reliable but are not verified, and Buyer must conduct and complete all performance and other testing of the products, alone and together with, or installed in, any end-products. Buyer shall not rely on any data and performance specifications or parameters provided by Microsemi. It is the Buyer’s responsibility to independently determine suitability of any products and to test and verify the same. The information provided by Microsemi hereunder is provided “as is, where is” and with all faults, and the entire risk associated with such information is entirely with the Buyer. Microsemi does not grant, explicitly or implicitly, to any party any patent rights, licenses, or any other IP rights, whether with regard to such information itself or anything described by such information. Information provided in this document is proprietary to Microsemi, and Microsemi reserves the right to make any changes to the information in this document or to any products and services at any time without notice. VSC3340-31 3.5 Gbps 40 × 40 Crosspoint Switch Speed and Protocol Support Key Specifications • 3.5 Gbps non-return-to-zero (NRZ) data bandwidth • 3.5 Gbps NRZ per channel data rate • Protocol-independent asynchronous operation • 2.5 V power supply • 23 mm × 23 mm flip chip ball grid array package Architecture • Fully non-blocking and multicasting switch core Related Products • Loss of signal (LOS) detection and forwarding (supports out-ofband signaling) Visit www.microsemi.com for information about these related products: • Fully asynchronous operation with