BL-L314IRAC

INFRARED EMITTING DIODES BL-L314XX-IR Features: 3.0mm Round Type Infrared LED High Reliability Peak Wavelength at 940, 880, 850nm Water Clear, yellow Transparent, Blue Transparent available IC compatible /Low current capability. Application Free air transmission system Infrared remote control units with high power requirement Smoke detector Infrared Camera Infrared applied system Electrical-optical characteristics: (Ta=25° C) Chip Part Number Material λP (nm) (Test Condition: IF=50mA) Lens Type ∆λ BL-L314IRAC BL-L314IRAB BL-L314IRBC BL-L314IRBB BL-L314IRCC BL-L314IRCB BL-L314IRCY GaAs GaAs 940 940 Water Clear Blue Trans. GaAlAs GaAlAs GaAlAs GaAlAs GaAlAs Absolute maximum ratings (Ta=25° C) Parameter Forward Current IF Power Dissipation Pd Reverse Voltage VR Peak Forward Current IPF (Duty 1/10 @1KHZ) Operation Temperature TOPR Storage Temperature TSTG Lead Soldering Temperature TSOL Rating 50 150 5 250 -40 to +80 -40 to +85 Max.260 5 for 3 sec Max. (1.6mm from the base of the epoxy bulb) Unit mA mW V mA w . w w 880 880 850 850 850 Water Clear Blue Trans. lu t e b 50 10 50 10 50 10 50 10 50 50 50 10 10 10 Ir (Vr=5V, uA) . x Typ 1.40 1.40 1.70 1.70 1.70 1.70 1.70 Forward Voltage(VF) Unit:V m o c Radiant Power (mw/sr) Typ 25 25 25 25 45 45 45 Viewing Angle 2θ1/2(deg) Max 1.60 1.60 2.00 2.00 2.00 2.00 2.00 40 Water Clear Blue Trans. Yellow Trans. APPROVED : XU L CHECKED :ZHANG WH DRAWN: LI FS REV NO: V.2 Page 1 of 3 WWW.BETLUX.COM EMAIL: SALES@BETLUX.COM , BETLUX@BETLUX.COM     ¢ ¢¡ INFRARED EMITTING DIODES BL-L314XX-IR Notes: 1. All dimensions are in millimeters (inches) 2. Tolerance is 0.25(0.01")unless otherwise noted. 3. Specifications are subject to change without notice. APPROVED : XU L CHECKED :ZHANG WH DRAWN: LI FS REV NO: V.2 Page 2 of 3 WWW.BETLUX.COM EMAIL: SALES@BETLUX.COM , BETLUX@BETLUX.COM ¤ £ Package configuration & Internal circuit diagram w . w w lu t e b ANODE . x m o c CATHODE INFRARED EMITTING DIODES BL-L314XX-IR 1 .0 0.5 0 350 (1) - GaAsP/GaAs 655nm/Red (2) - GaP 570nm/Yellow Green (3) - GaAsP/GaP 585nm/Yellow (4) - GaAsp/GaP 635nm/Orange & Hi-Eff Red (5) - GaP 700nm/Bright Red (6) - GaAlAs/GaAs 660nm/Super Red (8) - GaAsP/GaP 610nm/Super Red (9) - GaAlAs 880nm (10) - GaAs/GaAs & GaAlAs/GaAs 940nm (A) - GaN/SiC 430nm/Blue (B) - InGaN/SiC 470nm/Blue (C) - InGaN/SiC 505nm/Ultra Green (D) - InGaAl/SiC 525nm/Ultra Green 50 FORWARD CURRENT(mA) RELATIVE LUMINOUS INTENSITY 3 2 1 0.5 0.2 0.1 -30 -20 -10 1 8 64 5 23 4.0 40 30 20 10 0 1.2 3.0 1.6 2.0 2.4 2.6 FORWARD VOLTAGE (Vf) FORWARD CURRENT VS. FORWARD VOLTAGE w 0 10 FORWARD CURRENT (mA) RELATIVE LUMINOUS INTENSITY VS. FORWARD CURRENT AMBIENT TEMPERATURE Ta( ) FORWARD CURRENT VS. AMBIENT TEMPERATURE 1 5 4 2 3 10 9 8 7 6 5 4 3 2 20 30 40 50 60 70 1 1 Ipeak MAX. IDC MAX. 300KHz 3KHz 10KHz 1KHz 100KHz F-REFRESH RATE 3KHz 300Hz 30KHz 100KHz 10KHz 1KHz 100Hz 10 9 8 7 6 5 Ipeak MAX. IDC MAX. 4 3 2 1 1 10 100 1000 tp-PULSE DURATION uS (5) AMBIENT TEMPERATURE Ta( ) 10 100 1000 10,000 tp-PULSE DURATION uS (1,2,3,4,6,8,B.D.J.K) NOTE:25 free air temperature unless otherwise specified APPROVED : XU L CHECKED :ZHANG WH DRAWN: LI FS REV NO: V.2 Page 3 of 3 WWW.BETLUX.COM EMAIL: SALES@BETLUX.COM , BETLUX@BETLUX.COM ¦ e .b w w 2.0 1.0 0 3.0 20 40 60 lu t 1 5 B 100 80 § ¥ § £ Typical electrical-optical characteristics curves: (A) (B) (C) (D) (2) (3) (8) (4) (1) (6) (5) (9) (10) 400 450 500 550 600 650 700 750 800 850 900 950 1000 Wavelength(nm) RELATIVE INTENSITY Vs WAVELENGTH( p ) . x 50 40 30 20 10 0 FORWARD CURRENT(mA) m o c 20 40 60 80 100 RELATIVE LUMINOUS INTENSITY 1 6 2,4,8,A 3 5 10,000