OH300-71003SV-100.0M

Available at Digi-Key www.digikey.com OH300-71003SV-100.0M OCVCXO Description: 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com US Headquarters: 630-851-4722 European Headquarters: +353-61-472221 Features: Connor-Winfield's model OH30071003SV is a 3.3 Vdc, Sinewave output, Oven Compensated Voltage Controlled Crystal Oscillator (OCVCXO) in a 22 x 25.4mm surface mount package. The OH300-71003SV is designed for applications requiring very high frequency stability and low phase noise. • Output Frequency: 100.0 MHz • 3.3 Vdc Operation • 22 x 25.4 mm SMT Package • Frequency Stability: ±10 ppb • Temperature Range: -20 to 70°C • Sinewave Output • Low Jitter / Low Phase Noise • RoHS Compliant / Lead Free Absolute Maximum Ratings Parameter Minimum Nominal Maximum Units -55 -0.5 -1.0 3.13 - - - 3.30 125 4.5 7.0 3.47 °C Vdc Vdc Vdc Storage Temperature Supply Voltage (Vcc) Control Voltage (Vc) Operating Supply Voltage Notes Absolute Ratings: Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only. The functional operation of the device at those or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to conditions outside the "recommended operating conditions" for any extended period of time may adversely impact device reliability and result in failures not covered by warranty. Operating Specifications Parameter Minimum Parameter Minimum Nominal Maximum Units Notes Center Frequency (Fo) - 100.0 - MHz Operating Temperature -20 - 70 °C Frequency Calibration @ 25°C -0.1 - 0.1 ppm Frequency Stability vs. Temperature -10 - 10 ppb 1 Frequency vs. Supply Voltage -5.0 - 5.0 ppb Vcc ±5% Frequency vs. Load -2.0 - 2.0 ppb Load ±5% Aging: Daily -5.0 - 5.0 ppb/day 2 Aging: First Year -300 - 300 ppb Lifetime Tolerance: (20 years) -800 - 800 ppb 3 Supply Voltage (Vcc) 3.13 3.30 3.47 Vdc 4 Power Consumption: Vcc = 3.30 Vdc Steady State, @ 25°C - - 1.25 W 5 Turn On @ -20°C - - 2.75 W 5 Integrated Phase Jitter (BW: 12kHz to 20MHz) - - 0.5 ps rms Short Term Allan Deviation: (1s) - 5.0E-11 - Start-Up Time: - - 500 ms Warm Up Time: @ 25°C - - 5 minutes 6 Phase Noise SSB Phase Noise at 1Hz offset SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset - - - - - - Nominal -65 -90 -120 -127 -145 -150 Maximum - - - - - - dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz Units Notes Maximum Units Notes Input Characteristics Parameter Control Voltage Range Pull Range Input Impedance Minimum Nominal 0.3 ±0.6 100K 1.65 - - 3.0 - - V 7 ppm Ohm Ordering Information Bulletin Page Revision Date Cx282 1 of 4 01 07 Sept 2017 OH300-71003SV-100.0M Attention: System Designers please review Application Note AN2093: System Design Information: Printed Circuit Board Layout Guidelines for OCXO Oscillators. www.conwin.com/support.html 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Sinewave Output Characteristics Parameter Output Load Output Power: Harmonics; Spurious Output Minimum Nominal Maximum Units - +5 - - 50 - - - - - -30 -80 Ohm dBm dBc dBc Notes Notes: 1. Referenced to the frequency measured @ 25°C, Control voltage (Vc) = 1.65Vdc. 2. At time of shipment after 48 hours of operation. 3. Inclusive of Calibration, Operating Temperature, Supply Voltage change, Load change, and 20 Year Aging. 4. Supply voltage must reach Vcc levels monotonically within a ramp-up time of