LM78L05AA3

CYStech Electronics Corp. Three Terminal Low Current Positive Voltage Regulators Spec. No. : C515A3 Issued Date : 2003.03.26 Revised Date :2006.04.07 Page No. : 1/5 TO-92 LM78L05XA3 Description These regulators employ internal current-limiting and thermal-shutdown, making them essentially indestructible. They can deliver up to 100mA output current. if the case temperature can keep in Tc=25°C. They are intended as fixed voltage regulators in a wide range of applications including local (on-card) regulation for elimination of noise and distribution problems associated with single-point regulation. In addition, they can be used with power pass elements to make high-current voltage regulators. The LM78L05 used as a Zener diode/resistor combination replacement, offers an effective output impedance improvement of typically two orders of magnitude, along with lower quiescent current and lower noise. Absolute Maximum Ratings (Ta=25°C) • Input Voltage………………………………………………………………………………………………. 30 V • Total Power Dissipation……………………………………………………………………. Internally limited • Operating Temperature Range……………………………………………………………. 0 °C to +125 °C • Maximum Junction Temperature………………………………………………………………………125 °C • Storage Temperature Range………………………………………………………………-55 °C to +150 °C • Lead Temperature (Soldering 10S)……………………………….. ……………………………...260 °C Typical Application Schematic Diagram Vin Vin LM78L05 Vout 5k 5.7kΩ 576Ω 3.41kΩ 3.89kΩ 7.8kΩ 13kΩ 2.23kΩ 100 5p 100 1.5kΩ 1.9kΩ Vout C1 C2 Note: C1 and C2 are required if regulator is located far from power supply filter and load, or oscillation may induced on the loop. 2.84kΩ Gnd LM78L05XA3 CYStek Product Specification CYStech Electronics Corp. Ordering Information Device LM78L05AA3 LM78L05BA3 Output Voltage Tolerance 3% 5% Spec. No. : C515A3 Issued Date : 2003.03.26 Revised Date :2006.04.07 Page No. : 2/5 Electrical Characteristics Vin=10V, Iout=40mA, 0°C≤Tj≤125°C, Cin=0.33uF, Cout=0.1uF (unless otherwise noted) Symbol Parameter Conditions Tj=25°C 1mA≤Io≤70mA 1mA≤Io≤40mA and 7V≤Vin≤20V Tj=25°C, 7V≤Vin≤20V Tj=25°C, 8V≤Vin≤20V Tj=25°C, 1mA≤Io≤40mA Tj=25°C, 1mA≤Io≤100mA Tj=25°C Tj=125°C 1mA≤Io≤40mA 8V≤Vin≤20V Ta=25°C, 10Hz≤f≤10KHz 8V≤Vin≤16V, f=120Hz Tj=25°C Conditions Tj=25°C 1mA≤Io≤70mA 1mA≤Io≤40mA and 7V≤Vin≤20V Tj=25°C, 7V≤Vin≤20V Tj=25°C, 8V≤Vin≤20V Tj=25°C, 1mA≤Io≤40mA Tj=25°C, 1mA≤Io≤100mA Tj=25°C Tj=125°C with load with line Ta=25°C, 10Hz≤f≤10KHz 8V≤Vin≤16V, f=120Hz Tj=25°C LM78L05A Min Typ Max 4.85 5.00 5.15 4.85 5.15 4.85 47 3 40 62 1.7 5.15 150 100 30 100 6 5.5 0.1 1.5 mV mV mA mA uV dB V Units Units Vo Output Voltage V ∆Vo ∆Vo IQ ∆IQ Line Regulation Load Regulation Quiescent Current Quiescent Current with load Change with line Vn Output Noise Voltage ∆Vin / ∆Vout Ripple Rejection VD Dropout Voltage Symbol Parameter Vo Output Voltage LM78L05B Min Typ Max 4.80 5.00 5.20 4.75 5.25 4.75 47 3 40 62 1.7 5.25 150 100 30 100 6 5.5 0.1 1.5 - V ∆Vo ∆Vo IQ ∆IQ Line Regulation Load Regulation Quiescent Current mV mV mA mA uV dB V Quiescent Current with load Change with line Vn Output Noise Voltage ∆Vin / ∆Vout Ripple Rejection VD Dropout Voltage LM78L05XA3 CYStek Product Specification CYStech Electronics Corp. Characteristic Curves Dropout Characteristics 6 5 Output Voltage(V) 4 Io=1mA 10000 Spec. No. : C515A3 Issued Date : 2003.03.26 Revised Date :2006.04.07 Page No. : 3/5 Maximum Average Power Dissipation Power Dissipation (mW) Io=100mA 1000 3 2 1 0 Io=40mA 100 1 2 3 4 567 Input Voltage(V) 8 9 10 25 50 75 100 125 150 Ambient Temperature ( °C) Quiescent Current 3.4 VIN=10V Io=40mA Quiescent Current 4 3.5 Quiescent Current(mA) Quiescent Current(mA) 3 2.5 2 1.5 1 0.5 0 0 5 10 15 20 25 Input Voltage(V) 30 35 2.6 0 VIN=10V Io=40mA Tj=25℃ 3.2 3 2.8 50 100 Ambient Temperature(°C) 150 LM78L05XA3 CYStek Product Specification CYStech Electronics Corp. TO-92 Taping Outline Spec. No. : C515A3 Issued Date : 2003.03.26 Revised Date :2006.04.07 Page No. : 4/5 H2 H2 H2A H2A A D2 H3 L H4 H L1 H1 F1 F2 D1 D W1 W T2 T T1 P1 P P2 DIM A D D1 D2 F1,F2 F1,F2 H H1 H2 H2A H3 H4 L L1 P P1 P2 T T1 T2 W W1 LM78L05XA3 Item Component body height Tape Feed Diameter Lead Diameter Component Body Diameter Component Lead Pitch F1-F2 Height Of Seating Plane Feed Hole Location Front To Rear Deflection Deflection Left Or Right Component Height Feed Hole To Bottom Of Component Lead Length After Component Removal Lead Wire Enclosure Feed Hole Pitch Center Of Seating Plane Location 4 Feed Hole Pitch Over All Tape Thickness Total Taped Package Thickness Carrier Tape Thickness Tape Width Adhesive Tape Width 20 pcs Pitch Millimeters Min. 4.33 3.80 0.36 4.33 2.40 15.50 8.50 2.50 12.50 5.95 50.30 0.36 17.50 5.00 253 Max. 4.83 4.20 0.53 4.83 2.90 ±0.3 16.50 9.50 1 1 27 21 11 12.90 6.75 51.30 0.55 1.42 0.68 19.00 7.00 255 CYStek Product Specification CYStech Electronics Corp. TO-92 Dimension A B 1 2 3 Spec. No. : C515A3 Issued Date : 2003.03.26 Revised Date :2006.04.07 Page No. : 5/5 α2 α3 78L05 C D H I E F G α1 Style: Pin 1.Vout 2.GND 3.Vin 3-Lead TO-92 Plastic Package CYStek Package Code: A3 *: Typical DIM A B C D E F Inches Min. Max. 0.1704 0.1902 0.1704 0.1902 0.5000 0.0142 0.0220 *0.0500 0.1323 0.1480 Millimeters Min. Max. 4.33 4.83 4.33 4.83 12.70 0.36 0.56 *1.27 3.36 3.76 DIM G H I α1 α2 α3 Inches Min. Max. 0.0142 0.0220 *0.1000 *0.0500 *5° *2° *2° Millimeters Min. Max. 0.36 0.56 *2.54 *1.27 *5° *2° *2° Notes: 1.Controlling dimension: millimeters. 2.Maximum lead thickness includes lead finish thickness, and minimum lead thickness is the minimum thickness of base material. 3.If there is any question with packing specification or packing method, please contact your local CYStek sales office. Material: • Lead: 42 Alloy ; solder plating • Mold Compound: Epoxy resin family, flammability solid burning class: UL94V-0 Important Notice: • All rights are reserved. Reproduction in whole or in part is prohibited without the prior written approval of CYStek. • CYStek reserves the right to make changes to its products without notice. • CYStek semiconductor products are not warranted to be suitable for use in Life-Support Applications, or systems. • CYStek assumes no liability for any consequence of customer product design, infringement of patents, or application assistance. LM78L05XA3 CYStek Product Specification