KWL-1111UG

KWL-1111Ux SERIES Light Bar Display DESCRIPTION: The KWL-1111Ux series is 11.00mm x 11.00mm square type light bar display designed for a variety of applications where a large source of light is required, such as panel indicators, backlight legends and light arrays. PACKAGE DIMENSIONS 11.0(0.433) PIN 1 11.0(0.433) 10.0(0.394) 10.0(0.394) ABSOLUTE MAXIMUM RATINGS: (Ta=25 C) Parameter Max Reverse Voltage per segment 5V Reverse Current per segment (Vr = 5V) 100µA Derating Linear from 25oC per segment 0.4mA/ oC Operating Temperature Range -40oC To 85oC Storage Temperature Range -40oC To 100oC Soldering Temperature 1.6mm(1/16") from body for 5 sec. at 260oC NOTES : 1. All dimensions are in millimeters (inches). 2. Tolerance is +0.25mm(0.010) unless otherwise specified. 3. Specifications are subject to change without notice. 4. NP: No Pin. 5. NC: No Connect. 10.0(0.394) 6.30(0.248) o φ0.50(0.020) 2.54*3=7.62(0.3) INTERNAL CIRCUIT DIAGRAM 1 4 TESTING CONDITION FOR EACH PARAMETER : Parameter Forward Voltage Peak Emission Wave Length Spectral Line Half-Width Reverse Current Average Luminous Intensity Symbol Vf λρ ∆λ Ir Iv Unit V nm nm µA µ cd Test Condition If=20mA If=20mA If=20mA Vr=5V If=10mA 2 3 PART NO. SELECTION AND APPLICATION INFORMATION (RATINGS AT 25 C AMBIENT) Chip Part No. Raw Material GaAsP/GaP GaAlAs GaP GaP GaAsP/GaP Emitted Color Hi-Eff. Red Super Red Green Super Green Yellow No Common Polar C.C or C.A Wave Length λρ (nm) 635 660 565 570 585 Absolute Maximum Ratings ∆λ Pd If Electro-optical Characteristic o If If Vf (V) Iv (mcd) (Peak) (Rec) Per Chip (nm) (mW) (mA) (mA) Min. Typ. Max. mA Min. Typ. 45 20 30 30 30 100 100 100 100 100 50 50 50 50 50 100 100 100 100 100 1.7 1.5 1.7 1.7 1.7 1.9 1.9 2.2 2.2 1.9 2.6 10-20 2.5 2.6 10-20 6.0 2.6 10-20 2.0 2.6 10-20 4.0 2.6 10-20 2.0 6.0 12.0 5.0 10.0 5.0 KWL-1111U3 KWL-1111US KWL-1111U2 KWL-1111UG KWL-1111U6 REMARKS : 1. The average luminous intensity is obtained by summing the luminous intensity of each segment and dividing by the total number of segments. 2. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (International Commission on Illumination) eye-response curve. 3. Clean only by pure water, isopropanol, ethanol, Freon TF (or equivalent).