NID30S24-24

12.5~30W DC-DC Non-isolated Single Output Converter Features : Economical open frame design Wide input range High efficiency up to 96% Built-in remote ON / OFF control NID30 series Compact size 2.0" 0.512" 0.421"(SIP package) Cooling by free air convection Protections: Short circuit / Overload / Over voltage 100% burn-in test Low cost / High reliability SPECIFICATION ORDER NO. DC VOLTAGE CURRENT RANGE RATED POWER OUTPUT NID30S24-05 5V 0 ~ 2.5A 12.5W 12V 0 ~ 2.5A 30W 120mVp-p 2 years warranty NID30S24-12 NID30S24-15 15V 0 ~ 2A 30W 150mVp-p NID30S48-24 24V 0 ~ 1.25A 30W 200mVp-p RIPPLE & NOISE (max.) Note.2 100mVp-p LINE REGULATION Note.3 0.5% LOAD REGULATION VOLTAGE ACCURACY Note.4 0.5% 2.0% 68uf/16V low ESR 20 ~ 53VDC 24VDC (or 48VDC) 95% 1310mA 30mA 47uf/50V low ESR 20 ~ 53VDC 24VDC (or 48VDC) 96% 1320mA 30mA 30 ~ 53VDC 48VDC 93% 700mA 50mA SWITCHING FREQUENCY (Typ.) 250KHz EXTERNAL CAPACITANCE LOAD (max.) 100uF / 25V low ESR VOLTAGE RANGE NORMAL VOLTAGE EFFICIENCY (Typ.) INPUT DC CURRENT PROTECTION OVERLOAD (Typ.) PROTECTION SHORT CIRCUIT OVER VOLTAGE WORKING TEMP. No load 20 ~ 53VDC 24VDC (or 48VDC) 91% Full load 590mA 20mA Fuse recommended (3A) 120 ~ 300% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed All output equipped with short circuit Protection type : Hiccup mode, recovers automatically after fault condition is removed Protection type : Shut off o/p voltage, clamp by TVS diode (Refer to output load derating curve) RH non-condensing , 10 ~ 85% RH (0 ~ 50 ) -25 ~ +65 20% ~ 85% WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY -25 ~ +105 0.03% / TEMP. COEFFICIENT VIBRATION OTHERS REMOTE CONTROL DIMENSION WEIGHT 10 ~ 500Hz, 2G 10min./1 cycle, period for 60min. each along X, Y, Z axes Power on : 3.3VDC < R.C ~ com < 12VDC or open circuit ; power off : R.C ~ com < 0.4VDC or short circuit (PIN5,6 & PIN11) 50.8*13*10.7mm or 2.0"*0.512"*0.421" inch (L*W*H) 8g Mechanical Specification Unit:mm(inch) 10.7[0.421]max. 50.8 [2] 8 [0.315] Pin Configuration Pin No. 1,2,3,4 5,6 7,8 9,10 11 5.6 [0.22] -25 Derating Curve Output + Vo u t Com + Vi n N.C. R.C. 100 3.6 +1/-0[0.142] LOAD (%) 13 [0.512] 80 SIDE VIEW 12345 0.64 [0.025] 10.16 [0.40] 25.4 [1] 6 7 8 9 1011 50 1.3 [0.051] 2.54 [0.1] 0 25 55 60 65 100 Ta ( NOTE 1.All parameters are specified at normal input, rated load, 25 70% RH Ambient. 2.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor. 3.Line regulation is measured from low line to high line at rated load. 4.Load regulation is measured from 10% to 100% rated load. ) File Name:NID30-SPEC 2009-09-04