MT9V136W00STCK22BC1-750

‡ MT9V136: 1/4-Inch Color CMOS NTSC/PAL Digital Image Sensor Features 1/4-Inch Color CMOS NTSC/PAL Digital Image SOC with Overlay Processor MT9V136 Datasheet, Rev. J For the latest datasheet, please visit www.onsemi.com Features Table 1: • Low-power CMOS image sensor with integrated image flow processor (IFP) and video encoder • 1/4-inch optical format, VGA resolution (640H x 480V) • ±2.5% additional columns and rows to compensate for lens alignment tolerances • Overlay generator for dynamic bitmap overlay • Integrated video encoder for NTSC/PAL with overlay capability and 10-bit I-DAC • Integrated microcontroller for flexibility • On-chip image flow processor performs sophisticated processing, such as color recovery and correction, sharpening, gamma, lens shading correction, on-the-fly defect correction, auto white balancing, and auto exposure • Auto black level calibration • 10-bit, on-chip analog-to-digital converter (ADC) • Internal master clock generated by on-chip phaselocked loop (PLL) • Two-wire serial programming interface • Interface to low-cost Flash through SPI bus • High-level host command interface • Stand alone operation support • Comprehensive tool support for overlay generation and lens correction setup • Development system with DevWare • Overlay generation and compilation tools Key Parameters Parameter Typical Value Pixel size and type 5.6 m x 5.6 m active pinnedphotodiode with high-sensitivity mode for low-light conditions Sensor format 680H x 512V (includes ±2.5% of rows and columns for lens alignment) NTSC output 720H x 480V PAL output 720H x 576V Imaging area Total array size: 3.584 mm x 2.688 mm Optical format ¼-inch Frame rate 50/60 fields/sec Sensor scan mode Progressive scan Color filter array RGB standard Bayer Shutter type Electronic rolling shutter (ERS) Automatic Functions Exposure, white balance, black level offset correction, flicker avoidance, color saturation control, on-the-fly defect correction, aperture correction Programmable Controls Exposure, white balance, horizontal and vertical blanking, color, sharpness, gamma correction, lens shading correction, horizontal and vertical image flip, windowing, sampling rates, GPIO control Key parameters are continued on next page. See details of new features on page 3. Applications See “Ordering Information” on page 4. • Analog surveillance CCTV • Surveillance network IP camera MT9V136 DS Rev. J Pub. 6/15 EN 1 ©Semiconductor Components Industries, LLC 2015, MT9V136: 1/4-Inch Color CMOS NTSC/PAL Digital Image Sensor Applications Table 2: Key Parameters (continued) Parameter Typical Value Overlay Support1 Utilizes SPI interface to load overlay data from external flash/EEPROM memory with the following features: •Overlay Size 360 x 480 pixel rendered into 720 x 480 pixel display format •Up to four (4) overlays may be blended simultaneously •Selectable readout: Rotating order user selected •Dynamic scenes by loading pre-rendered frames from external memory •Palette of 32 colors out of 64,000 •8 colors per bitmap •Blend factor dynamically programmable for smooth transitions •Fast Update rate of up to 30 fps •Every bitmap object has independent x/y position •Statistic Engine to calibrate optical alignment •Number Generator Windowing Programmable to any size Max analog gain 0.5–16x ADC 10-bit, on-chip Output interface Analog composite video out, single-ended or differential; 8-, 10-bit parallel digital output Output data formats1 Digital: Raw Bayer 8-,10-bit, CCIR656, 565RGB, 555RGB, 444RGB Parallel: 27 MB/s NTSC: 60 fields/sec Data rate PAL: 50 fields/sec Control interface Two-wire I/F for register interface plus high-level command exchange. SPI port to interface to external memory to load overlay data, register settings, or firmware extensions. Input clock for PLL 27 MHz SPI Clock Frequencies 4.5 - 9.0 - 18 MHz, programmable Analog: 2.8 V ±5% Core: 1.8 V ±5% Supply voltage IO: 2.8V ±5% Full resolution at 60 fps: