835-IF38.9M-E

Oscilent Corporation IF SAW Filter | 835-IF38.9M-E Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 835-IF38.9M-E TYPE : 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 38.9 MHz Bandpass Filter PART NUMBER : 835-IF38.9M-E OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss at Fo Source Impedance (single ended)* Load Impedance (single ended)* Temperature Coefficient Amplitude Ripple (34.2~39.4 MHz) Relative Attenuation (relative to Fo) 33.40 MHz 34.00 MHz 34.10 MHz 39.65 MHz 25.00 MHz~ 32.00 MHz 32.00 MHz~ 32.65 MHz 32.65 MHz~ 33.30 MHz 40.15 MHz~ 41.20 MHz 41.20 MHz~ 45.00 MHz Reflected wave signal suppression Group Delay Variation (p-p); smo 1% Absolute Delay at Fo 42 -0.5 -0.5 0.5 50 48 45 45 48 50 48 0.1 0.1 1.0 58 58 55 54 55 58 48 4.15 Minimum Typical 38.9 27.5 50 50 0.5 1.0 0.6 1.5 60 4.3 dB dB dB dB dB dB dB dB dB dB ns µs Maximum 30.0 94 1.0 Units MHz dB ohm ohm ppm/°C dBp-p * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 835-IF38.9M-E Page 2 of 3 PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case, Index- Left bottom of Marking TEST ENVIRONMENT Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 835-IF38.9M-E Page 3 of 3 Part No.: 835-IF38.9M-E Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map