BUF460AV_03

® BUF460AV NPN TRANSISTOR POWER MODULE s s s s s s EASY TO DRIVE TECHNOLOGY (ETD) HIGH CURRENT POWER BIPOLAR MODULE VERY LOW Rth JUNCTION CASE SPECIFIED ACCIDENTAL OVERLOAD AREAS FULLY INSULATED PACKAGE (U.L. COMPLIANT) FOR EASY MOUNTING LOW INTERNAL PARASITIC INDUCTANCE APPLICATIONS: MOTOR CONTROL s SMPS & UPS s WELDING EQUIPMENT s ISOTOP INTERNAL SCHEMATIC DIAGRAM ABSOLUTE MAXIMUM RATINGS Symbol V CEV V CEO(sus) VEBO IC I CM IB I BM P tot V isol T stg Tj Parameter Collector-Emitter Voltage (V BE = -5 V) Collector-Emitter Voltage (I B = 0 ) Emitter-Base Voltage (I C = 0 ) Collector Current Collector Peak Current (t p = 1 0 ms) Base Current Base Peak Current (t p = 1 0 ms) Total Dissipation at T c = 2 5 o C Insulation Withstand Voltage (RMS) from All Four Terminals to External Heatsink Storage Temperature Max Operation Junction Temperature Value 1000 450 7 80 160 18 27 270 2500 -65 to 150 150 Unit V V V A A A A W o o C C February 2003 1/7 BUF460AV THERMAL DATA R thj-case R thc-h Thermal Resistance Junction-case Max Thermal Resistance Case-heatsink With Conductive Grease Applied Max 0.41 0.05 o o C/W C/W ELECTRICAL CHARACTERISTICS (Tcase = 25 oC unless otherwise specified) Symbol I CER I CEV I EBO Parameter Collector Cut-off Current (R BE = 5 Ω ) Collector Cut-off Current (V BE = - 1.5V) Emitter Cut-off Current (I C = 0 ) Test Conditions V CE = V CEV V CE = V CEV V CE = V CEV V CE = V CEV V EB = 5 V I C = 0 .2 A L = 25 mH V clamp = 4 50 V IC = 60 A IC IC IC IC = = = = 30 30 60 60 A A A A VCE = 5 V IB IB IB IB = = = = 3A o 3 A T j = 1 00 C 12 A 1 2 A T j = 1 00 o C T j = 1 00 o C 150 4 2 4.5 0.1 0.3 400 6 3 5 0.2 5 450 T j = 1 00 o C T j = 1 00 C o Min. Typ. Max. 0.2 2 0.2 2 1 Unit mA mA mA mA mA V VCEO(sus) * Collector-Emitter Sustaining Voltage (I B = 0 ) h FE ∗ V CE(sat) ∗ DC Current Gain Collector-Emitter Saturation Voltage 15 0.35 2 0.5 2 1.1 1.5 V V V V V V A/ µ s V V µs µs µs V V BE(sat) ∗ di C /dt Base-Emitter Saturation Voltage Rate of Rise of On-state Collector IC = 60 A IC = 60 A V CC = 3 00 V I B1 = 1 8 A V CC = 3 00 V I B1 = 1 8 A V CC = 3 00 V I B1 = 1 8 A IB = 12 A IB = 12 A RC = 0 tp = 3 µ s T j = 1 00 o C RC = 30 Ω T j = 1 00 o C RC = 30 Ω T j = 1 00 o C V CE (3 µ s)• Collector-Emitter Dynamic Voltage V CE (5 µ s)• Collector-Emitter Dynamic Voltage ts tf tc V CEW Storage Time Fall Time Cross-over Time Maximum Collector Emitter Voltage Without Snubber IC = 30 A V CC = 5 0 V R BB = 0 .2 Ω V BB = -5 V V clamp = 4 00 V I B1 = 3 A L = 25 µ H T j = 1 00 o C I CWoff = 8 0 A V BB = -5 V L = 80 µ H T j = 1 25 o C I B1 = 1 6 A V CC = 5 0 V R BB = 0 .2 Ω ∗ Pulsed: Pulse duration = 300 µs, duty cycle 1.5 % 2/7 BUF460AV Safe Operating Area Thermal Impedance Derating Curve Collector-Emitter Voltage Versus Base-Emitter Resistance Collector-Emitter Saturation Voltage Base-Emitter Saturation Voltage 3/7 BUF460AV Reverse Biased SOA Forward Biased SOA Reverse Biased SOA Forward Biased SOA Switching Time Inductive Load Switching Time Inductive Load Versus Temperature 4/7 BUF460AV DC Current Gain Turn-off Switching Test Circuit 1) Fast electronic switch 2) Non-inductive Resistor Turn-on Switching Waveforms. Turn-off Switching Test Circuit Turn-off Switching Waveforms. 1) Fast electronic switch 3) Fast recovery rectifier 2) Non-inductive Resistor 5/7 BUF460AV ISOTOP MECHANICAL DATA DIM. MIN. A A1 B C C2 D D1 E E1 E2 G G1 G2 F F1 P P1 S 14.9 12.6 3.5 4.1 4.6 4 4 30.1 11.8 8.9 7.8 0.75 1.95 37.8 31.5 25.15 23.85 24.8 15.1 12.8 4.3 4.3 5 4.3 4.4 30.3 0.586 0.496 0.137 0.161 0.181 0.157 0.157 1.185 mm TYP. MAX. 12.2 9.1 8.2 0.85 2.05 38.2 31.7 25.5 24.15 MIN. 0.465 0.350 0.307 0.029 0.076 1.488 1.240 0.990 0.938 0.976 0.594 0.503 1.169 0.169 0.196 0.169 0.173 1.193 inch TYP. MAX. 0.480 0.358 0.322 0.033 0.080 1.503 1.248 1.003 0.950 P093A 6/7 BUF460AV Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specification mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. The ST logo is a trademark of STMicroelectronics © 2003 STMicroelectronics – Printed in Italy – All Rights Reserved STMicroelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan - Malaysia - Malta - Morocco Singapore - Spain - Sweden - Switzerland - United Kingdom - United States. http://www.st.com 7/7