TS9013KCW

TS9013 500mA CMOS Low Dropout Voltage Regulator Pin assignment SOT-89 1. Gnd 2. Input 3. Output SOT-223 1. Input 2. Gnd 3. Output Low Power Consumption 2uA(typ) Low Drop Out Voltage 0.6V General Description The TS9013 series is a positive voltage regulator developed utilizing CMOS technology featured very low power consumption, low dropout voltage and high output voltage accuracy. Built in low on-resistor provides low dropout voltage and large output current. A 1uF or greater can be used as an output capacitor. The TS9013 series are prevented device failure under the worst operation condition with both thermal shutdown and current fold-back. These series are recommended for configuring portable devices and large current application, respectively. This series are offered in 3-pin SOT-89 and SOT-223 package. Features Dropout voltage typically 0.4V @Io=500mA (Vo=5V) Output current up to 500mA Low power consumption, 2uA(typ) @Vo=5V Output voltage +/-2% Internal current limit Thermal shutdown protection Ordering Information Part No. TS9013xCW Operating Temp. (Ambient) -20 ~ +85 oC Package SOT-223 Applications Palmtops Video recorders Battery powered equipment PC peripherals CD-ROM, DVD ROM Digital signal camera TS9013xCY SOT-89 Note: Where x denotes voltage option, available are A=1.5V, D=1.8V, K=2.5V, S=3.3V, 5=5.0V. Contact factory for additional voltage options. Block Diagram Typical Application Circuit TS9013 series 1-3 2004/09 rev. E Absolute Maximum Rating Input Supply Voltage Input Operating Voltage Output Current Power Dissipation (without heat sink) SOT-89 SOT-223 SOT-89 SOT-223 SOT-89 SOT-223 Vin(max.) Vin(opr. Typ.) Io PD +12 +10 PD / (Vin – Vo) 0. 55 0.625 180 160 18 15 -40 ~ +125 -65 ~ +150 10 o o V V W Thermal Resistance RӨja C/W Thermal Resistance Operating Junction Temperature Range Storage Temperature Range Lead Soldering Temperature (260 C) o RӨjc Tj TSTG C/W o o C C S Caution: Stress above the listed absolute rating may cause permanent damage to the device. Electrical Characteristics Ta = 25 oC unless otherwise specified. Parameter Conditions TS90135 TS9013S TS9013K TS9013D TS9013A Min 4.900 3.234 2.450 1.764 1.47 500 --- Typ 5.0 3.3 2.5 1.8 1.5 -0.2 40 Max 5.100 3.366 2.550 1.836 1.575 -0.3 80 Unit Output Voltage Vin=Vo + 1V, Io =10mA, V Maximum Output Current Input Stability Vin=Vo+1V, Vo+1V ≤ Vin ≤ Vo+2V, Io=1mA Vin=Vo+1V, 1mA≤IL≤500mA TS90135 TS9013S TS9013K TS9013D TS9013A TS90135 TS9013S TS9013K Io=400mA TS9013D TS9013A mA % Load Regulation (Note1) Vin=Vo+1V, 1mA≤IL≤400mA Io=500mA mV ---------40 600 600 600 600 850 2 550 30 90 750 750 850 850 1100 5 --uA mA dB mV Dropout Voltage (Note 2) Quiescent Current Output Current Limit Power Supply Rejection Ratio Output Voltage Temperature Vin=Vo+1V, Io=0A Vout < 0.4V At f=100KHz, Io=10mA, -100 -ppm/ oC Coefficient (Note 3) Note: 1. Regulation is measured at constant junction temperature, using pulsed ON time. 2. Dropout is measured at constant junction temperature, using pulsed ON time, and the criterion is Vout inside target value +/-2%. 3. Guaranteed by design. TS9013 series 2-3 2004/09 rev. E SOT-89 Mechanical Drawing A B I DIM A B C D E F J H G C SOT-89 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 4.40 4.60 0.173 0.181 1.50 1.7 0.059 0.070 2.30 2.60 0.090 0.102 0.40 0.52 0.016 0.020 1.50 1.50 0.059 0.059 3.00 3.00 0.118 0.118 0.89 4.05 1.4 0.35 1.20 4.25 1.6 0.44 0.035 0.159 0.055 0.014 0.047 0.167 0.068 0.017 E D G H I J F SOT-223 Mechanical Drawing A B I DIM A B C D E F G H I J K SOT-223 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 6.350 2.900 3.450 0.595 4.550 2.250 0.835 6.700 0.250 10° 1.550 6.850 3.100 3.750 0.635 4.650 2.350 1.035 7.300 0.355 16° 1.800 0.250 0.114 0.136 0.023 0.179 0.088 0.032 0.263 0.010 10° 0.061 0.270 0.122 0.148 0.025 0.183 0.093 0.041 0.287 0.014 16° 0.071 H C J K F G E D TS9013 series 3-3 2004/09 rev. E