CLVTH16244AMDGGREP

SN74LVTH16244A-EP 3.3-V ABT 16-BIT BUFFER/DRIVER WITH 3-STATE OUTPUTS www.ti.com SCAS692F – APRIL 2003 – REVISED APRIL 2007 FEATURES • • • • • • • • • • • • • • (1) Controlled Baseline – One Assembly/Test Site, One Fabrication Site Extended Temperature Performance of up to –40°C to 85°C, –40°C to 125°C and –55°C to 125°C Enhanced Diminishing Manufacturing Sources (DMS) Support Enhanced Product-Change Notification Qualification Pedigree (1) Member of the Texas Instruments Widebus™ Family State-of-the-Art Advanced BiCMOS Technology (ABT) Design for 3.3-V Operation and Low Static-Power Dissipation Supports Mixed-Mode Signal Operation (5-V Input and Output Voltages With 3.3-V VCC) Supports Unregulated Battery Operation Down to 2.7 V Typical VOLP (Output Ground Bounce) VCC. The package thermal impedance is calculated in accordance with JESD 51-7. Recommended Operating Conditions (1) VCC Supply voltage VIH High-level input voltage VIL Low-level input voltage VI Input voltage IOH High-level output current IOL Low-level output current ∆t/∆v Input transition rise or fall rate (1) 4 Operating free-air temperature MAX 2.7 3.6 2 V V V 5.5 V –24 SN74LVTH16244AI –32 SN74LVTH16244AM –24 SN74LVTH16244AQ 24 SN74LVTH16244AI 64 SN74LVTH16244AM 24 Outputs enabled UNIT 0.8 SN74LVTH16244AQ ∆t/∆VCC Power-up ramp rate TA MIN 10 mA mA ns/V µs/V 200 SN74LVTH16244AQ –40 125 SN74LVTH16244AI –40 85 SN74LVTH16244AM –55 125 °C All unused control inputs of the device must be held at VCC or GND to ensure proper device operation. See the TI application report, Implications of Slow or Floating CMOS Inputs, literature number SCBA004. Submit Documentation Feedback SN74LVTH16244A-EP 3.3-V ABT 16-BIT BUFFER/DRIVER WITH 3-STATE OUTPUTS www.ti.com SCAS692F – APRIL 2003 – REVISED APRIL 2007 Electrical Characteristics over recommended operating free-air temperature range (unless otherwise noted) PARAMETER VIK TEST CONDITIONS II = –18 mA VCC TYP (1) 2.7 V IOH = –100 µA 2.7 V to 3.6 V IOH = –8 mA 2.7 V 'LVTH16244AQ IOH = –24 mA VOH MIN MAX UNIT –1.2 V VCC – 0.2 2.4 2 'LVTH16244AI 'LVTH16244AM 'LVTH16244AQ IOH = –32 mA 3V 'LVTH16244AI V 2 2 'LVTH16244AM IOL = 100 µA 0.2 2.7 V IOL = 24 mA 0.5 IOL = 16 mA 0.4 'LVTH16244AQ VOL IOL = 32 mA 'LVTH16244AI 'LVTH16244AM 0.5 V 3V 'LVTH16244AQ IOL = 64 mA 'LVTH16244AI 0.55 'LVTH16244AM 'LVTH16244AQ VI = 5.5 V 'LVTH16244AI 50 0 V or 3.6 V 10 'LVTH16244AM II Control inputs Data inputs 50 ±1 VI = VCC or GND 3.6 V VI = VCC µA 1 VI = 0 V –5 'LVTH16244AQ Ioff VI or VO = 0 V to 4.5 V 'LVTH16244AI ±100 0V µA 'LVTH16244AM VI = 0.8 V 3V VI = 2 V II(hold) Data inputs 75 –75 'LVTH16244AQ VI = 0 V to 3.6 V 'LVTH16244AI µA 500 –750 3.6 V (2) 'LVTH16244AM 3.6 V 5 µA –5 µA ±100 µA IOZH VO = 3 V IOZL VO = 0.5 V IOZPU VO = 0.5 V to 3 V, OE = Don't care 0 V to 1.5 V IOZPD VO = 0.5 V to 3 V, OE = Don't care 1.5 V to 0 V ±100 µA 3.6 V Outputs high IO = 0 , VI = VCC or GND ICC ∆ICC (3) One input at VCC – 0.6 V, Other inputs at VCC or GND Ci VI = 3 V or 0 V (1) (2) (3) Outputs low 0.19 3.6 V 5 Outputs disabled mA 0.19 3 V to 3.6 V 0.2 0.2 4 mA pF All typical values are at VCC = 3.3 V, TA = 25°C. This is the bus-hold maximum dynamic current. It is the minimum overdrive current required to switch the input from one state to another. This is the increase in supply current for each input that is at the specified TTL voltage level, rather than VCC or GND. Submit Documentation Feedback 5 SN74LVTH16244A-EP 3.3-V ABT 16-BIT BUFFER/DRIVER WITH 3-STATE OUTPUTS www.ti.com SCAS692F – APRIL 2003 – REVISED APRIL 2007 Electrical Characteristics (continued) over recommended operating free-air temperature range (unless otherwise noted) PARAMETER Co TEST CONDITIONS VCC TYP (1) MIN VO = 3 V or 0 V MAX UNIT 9 pF Switching Characteristics over recommended operating free-air temperature range, CL = 50 pF (unless otherwise noted) (see Figure 1) SN74LVTH16244AQ/M PARAMETER tPLH tPHL tPZH tPZL tPHZ tPLZ FROM (INPUT) TO (OUTPUT) A Y OE Y OE Y VCC = 3.3 V ± 0.3 V SN74LVTH16244AI VCC = 2.7 V MIN VCC = 2.7 V MAX MAX MIN TYP MAX 1.1 4.4 4.6 1.2 2.5 3.2 3.7 1.1 3.6 3.9 1.2 2 3.2 3.7 1.1 4.6 5.4 1.2 2.6 4 5 1.1 5.4 6.2 1.2 2.7 4 5 1.6 5.7 6.2 2.2 3.3 4.5 5 1.2 5 4.7 2 3.1 4.2 4.4 0.5 Submit Documentation Feedback MIN UNIT MIN tsk(o) 6 VCC = 3.3 V ± 0.3 V MAX ns ns ns ns SN74LVTH16244A-EP 3.3-V ABT 16-BIT BUFFER/DRIVER WITH 3-STATE OUTPUTS www.ti.com SCAS692F – APRIL 2003 – REVISED APRIL 2007 PARAMETER MEASUREMENT INFORMATION 6V 500 Ω From Output Under Test S1 Open GND CL = 50 pF (see Note A) 500 Ω TEST S1 tPLH/tPHL tPLZ/tPZL tPHZ/tPZH Open 6V GND 2.7 V LOAD CIRCUIT Timing Input 1.5 V 0V tw tsu 2.7 V Input 1.5 V th 2.7 V 1.5 V Data Input 1.5 V 1.5 V 0V 0V VOLTAGE WAVEFORMS PULSE DURATION VOLTAGE WAVEFORMS SETUP AND HOLD TIMES 2.7 V Input 1.5 V 1.5 V 0V tPHL tPLH VOH Output 1.5 V 1.5 V VOL tPHL Output Waveform 1 S1 at 6 V (see Note B) 1.5 V 1.5 V VOL VOLTAGE WAVEFORMS PROPAGATION DELAY TIMES INVERTING AND NONINVERTING OUTPUTS 1.5 V 1.5 V 0V tPZL tPLZ 3V 1.5 V tPZH tPLH VOH Output 2.7 V Output Control Output Waveform 2 S1 at GND (see Note B) VOL + 0.3 V VOL tPHZ 1.5 V VOH − 0.3 V VOH ≈0 V VOLTAGE WAVEFORMS ENABLE AND DISABLE TIMES LOW- AND HIGH-LEVEL ENABLING NOTES: A. CL includes probe and jig capacitance. B. Waveform 1 is for an output with internal conditions such that the output is low, except when disabled by the output control. Waveform 2 is for an output with internal conditions such that the output is high, except when disabled by the output control. C. All input pulses are supplied by generators having the following characteristics: PRR ≤ 10 MHz, ZO = 50 Ω, tr ≤ 2.5 ns, tf ≤ 2.5 ns. D. The outputs are measured one at a time, with one transition per measurement. Figure 1. Load Circuit and Voltage Waveforms Submit Documentation Feedback 7 PACKAGE OPTION ADDENDUM www.ti.com 10-Dec-2020 PACKAGING INFORMATION Orderable Device Status (1) Package Type Package Pins Package Drawing Qty Eco Plan (2) Lead finish/ Ball material MSL Peak Temp Op Temp (°C) Device Marking (3) (4/5) (6) 8W244AMDGGREPG4 ACTIVE TSSOP DGG 48 2000 RoHS & Green NIPDAU Level-1-260C-UNLIM -55 to 125 H16244AMEP CLVTH16244AIDGVREP ACTIVE TVSOP DGV 48 2000 RoHS & Green NIPDAU Level-1-260C-UNLIM -40 to 85 LL244AEP CLVTH16244AMDGGREP ACTIVE TSSOP DGG 48 2000 RoHS & Green NIPDAU Level-1-260C-UNLIM -55 to 125 H16244AMEP CLVTH16244AQDGGREP ACTIVE TSSOP DGG 48 2000 RoHS & Green NIPDAU Level-1-260C-UNLIM -40 to 125 LH16244AEP CLVTH16244AQDLREP ACTIVE SSOP DL 48 1000 RoHS & Green NIPDAU Level-1-260C-UNLIM -40 to 125 LH16244AEP V62/04601-01XE ACTIVE SSOP DL 48 1000 RoHS & Green NIPDAU Level-1-260C-UNLIM -40 to 125 LH16244AEP V62/04601-01YE ACTIVE TSSOP DGG 48 2000 RoHS & Green NIPDAU Level-1-260C-UNLIM -40 to 125 LH16244AEP V62/04601-02ZE ACTIVE TVSOP DGV 48 2000 RoHS & Green NIPDAU Level-1-260C-UNLIM -40 to 85 LL244AEP V62/04601-03YE ACTIVE TSSOP DGG 48 2000 RoHS & Green NIPDAU Level-1-260C-UNLIM -55 to 125 H16244AMEP (1) The marketing status values are defined as follows: ACTIVE: Product device recommended for new designs. LIFEBUY: TI has announced that the device will be discontinued, and a lifetime-buy period is in effect. NRND: Not recommended for new designs. Device is in production to support existing customers, but TI does not recommend using this part in a new design. PREVIEW: Device has been announced but is not in production. Samples may or may not be available. OBSOLETE: TI has discontinued the production of the device. (2) RoHS: TI defines "RoHS" to mean semiconductor products that are compliant with the current EU RoHS requirements for all 10 RoHS substances, including the requirement that RoHS substance do not exceed 0.1% by weight in homogeneous materials. Where designed to be soldered at high temperatures, "RoHS" products are suitable for use in specified lead-free processes. TI may reference these types of products as "Pb-Free". RoHS Exempt: TI defines "RoHS Exempt" to mean products that contain lead but are compliant with EU RoHS pursuant to a specific EU RoHS exemption. Green: TI defines "Green" to mean the content of Chlorine (Cl) and Bromine (Br) based flame retardants meet JS709B low halogen requirements of