MUR115GP

Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 MUR105GP THRU MUR160GP 1.0 Amp Glass Passivated Super Fast Recovery Rectifier 50 to 600 Volts DO-41 Features • • • • High Surge Capability Low Forward Voltage Drop High Current Capability Super Fast Switching Speed For High Efficiency Maximum Ratings • • Operating Temperature: -65°C to +150°C Storage Temperature: -65°C to +150°C Maximum Recurrent Peak Reverse Voltage 50V 100V 150V 200V 400V 600V Maximum RMS Voltage 35V 70V 105V 140V 280V 420V Maximum DC Blocking Voltage 50V 100V 150V 200V 400V 600V Part Number MUR105GP MUR110GP MUR115GP MUR120GP MUR140GP MUR160GP D Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 1.0A TA = 55°C Current Peak Forward Surge IFSM 25A 8.3ms, half sine Current Maximum Instantaneous Forward Voltage VF IFM = 1.0A; MUR105GP-115GP .97V 1.35V TA = 25°C MUR120GP-160GP Maximum DC 5.0µA TA = 25°C Reverse Current At IR Rated DC Blocking TA = 150°C 50µA Voltage Maximum Reverse Recovery Time Trr MUR105GP-140GP 45ns IF=0.5A, IR=1.0A, Irr=0.25A 60ns MUR160GP Typical Junction Capacitance CJ MUR105GP-115GP 15pF Measured at 10pF 1.0MHz, VR=4.0V MUR120GP-160GP *Pulse Test: Pulse Width 300µsec, Duty Cycle 1% A Cathode Mark B D C DIMENSIONS INCHES DIM A B C D MIN .166 .080 .028 1.000 MAX .205 .107 .034 --MIN 4.10 2.00 .70 25.40 MM MAX 5.20 2.70 .90 --NOTE www.cnelectr.com MUR105GP thru MUR160GP Figure 1 Typical Forward Characteristics 20 10 6 4 2 25°C Amps 1 .6 .4 .2 MUR120GP-160GP .1 .06 .04 .02 .01 .5 .7 .9 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts 1.1 1.3 1.5 0 .25 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 50 75 100 °C Average Forward Rectified Current - Amperes versus Ambient Temperature - °C 125 150 175 Amps .5 1.0 MUR105GP-115GP 1.5 Figure 2 Forward Derating Curve 1.25 .75 Figure 3 Junction Capacitance 100 MUR105GP-115GP 60 40 MUR120GP-160GP 20 pF 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 TJ=25°C Junction Capacitance - pF versus Reverse Voltage - Volts www.cnelectr.com MUR105GP thru MUR160GP Figure 4 Typical Reverse Characteristics 100 60 40 20 10 6 4 2 TA=100°C µAmps 1 .6 .4 .2 .1 .06 .04 .02 .01 2 4 60 80 Volts Instantaneous Reverse Leakage Current - MicroAmperes versus Percent Of Rated Peak Reverse Voltage - Volts Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 100 120 140 TA=25°C 0 1 2 4 6 8 10 Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles 20 40 60 80 100 Amps 10 TA=150°C 20 30 Figure 5 Peak Forward Surge Current 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive www.mccsemi.com