6561

Model 6372, 6559, 6560, 6561 Male Mini-Connector “Do-It-Yourself” FEATURES: • Molded in contacts assure precision alignment • Matching thermocouple alloys reduce EMF • Channel design isolates wires for clear, strong signals • Make your own extension cables MATERIALS: Insulator – Hytrel 4776. MODEL NUMBER 6372 6559 6560 6561 CALIBRATION K J E T COLOR Yellow Black Violet Blue RATINGS: Maximum Ambient Temperature - 400°F. (205°C.). Maximum Wire Size – 20AWG (solid), 22 AWG (stranded) ORDERING INFORMATION: Model 6372, 6559, 6560, 6561 Note: For low voltage environments do not exceed 30VAC/60VDC. All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 7/10/02 SY/EH/LS Last saved by Laura Goldberg S ales:800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 PomonaACCESS 90739 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 1 of 2 C:\Laura Goldberg\FlukeDataSheet \d6372_6559-60-61_2_02.doc Model 6372, 6559, 6560, 6561 Male Mini-Connector “Do-It-Yourself” ASSEMBLY INSTRUCTIONS 1. 2. 3. Using a flat tip screwdriver, remove lid from connector. Cut back extension wire jacket (if applicable) 5/8”, strip back individual wires ¼”. Remove the elastomer strain relief from the connector. Insert wires into the strain relief until flush with the extension wire outer jacket (5/8”). Loosen the two wire terminal screws (Approximately 3 ½ turns counter clockwise) using a small flat tip screwdriver. Insert the stripped Red* wire under the (-) terminal screw, and the remaining wire under the (+) terminal screw. Tighten down the two terminal screws. Install the lid and tighten down the lid screw. 4. 5. 6. *Color may vary outside of the USA. All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 7/10/02 SY/EH/LS Last saved by Laura Goldberg S ales:800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 PomonaACCESS 90739 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 2 of 2 C:\Laura Goldberg\FlukeDataSheet \d6372_6559-60-61_2_02.doc