VN540SP-E

VN540SP-E Single high-side smart power solid state relay Datasheet - production data  Protection against: – Loss of ground – Shorted load and overtemperature  Built-in current limiter  Undervoltage shutdown PowerSO-10  Open drain diagnostic output TM  Fast demagnetization of inductive loads Description Features  10 V to 36 V supply voltage range  Up to IOUT = 2.8 A operating current  RDS(on) = 50 m  Vdemag = VCC - 55 V  Digital input clamped at 32 V The VN540SP-E is a monolithic devices designed in STMicroelectronics VIPower technology, intended for driving resistive or inductive loads with one side connected to ground. Active current limitation avoids the system power supply dropping in case of shorted load. Built-in thermal shutdown protects the chip from overtemperature. The open drain diagnostic output indicates overtemperature conditions. Figure 1. Block diagram October 2020 This is information on a product in full production. DocID11741 Rev 3 1/15 www.st.com Contents VN540SP-E Contents 1 Absolute maximum rating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2 Pin connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3 Thermal data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 4 Electrical characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 5 Switching characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 6 Truth table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 7 Test circuits and waveforms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 8 Package information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 8.1 PowerSO-10 package information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 9 Ordering information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 10 Revision history . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 2/15 DocID11741 Rev 3 VN540SP-E 1 Absolute maximum rating Absolute maximum rating Table 1. Absolute maximum rating Symbol Parameter VCC Power supply voltage -VCC Reverse supply voltage IOUT Maximum DC load current Value Unit 45 V -4.0 V Internally limited A IR Reverse output current -10 A IIN Input current ± 10 mA ISTAT Status pin current ± 10 mA VESD Electrostatic discharge (R = 1.5 KW; C = 100 pF) 2000 V PTOT Power dissipation (see thermal thresholds in Table 6 on page 7) Internally limited W Junction operating temperature Internally limited °C -55 to 150 °C 17 J TJ TSTG Storage temperature EAS Single pulse avalanche energy (Tamb = 125 °C, VCC = 24 V, Iload = 2.5 A) DocID11741 Rev 3 3/15 15 Pin connections 2 VN540SP-E Pin connections Figure 2. Connection diagram (top view) Figure 3. Current and voltage conventions 4/15 DocID11741 Rev 3 VN540SP-E 3 Thermal data Thermal data Table 2. Thermal data Symbol Parameter Value Unit RthJC Thermal resistance junction-case Max. 1.5 °C/W RthJA Thermal resistance junction-ambient Max. 50 °C/W DocID11741 Rev 3 5/15 15 Electrical characteristics 4 VN540SP-E Electrical characteristics Electrical characteristics (10 V < VCC < 36 V; -25 °C < TJ < 85 °C; unless otherwise specified). Table 3. Power section Symbol Parameter Test conditions Min. Typ. Max. Unit 10 - 36 V VCC Supply voltage RON On state resistance IOUT = 2.8 A; TJ = 25 °C IOUT = 2.8 A - - 50 90 m m IS Supply current OFF state ON state; TJ = 125 °C IOUT = 0 A - - 1 3 mA mA ILS Output leakage current Channel OFF VCC = 45 V - - 100 A ILGND Output current at turn-off VCC = VIN = VGND = VSTAT = 24 V TJ = - 25 °C < TJ < 100 °C - - 2 mA VOL Low state output voltage VIN = VIL; RLOAD  10 M - - 1.5 V Vdemag Output voltage at turn-off IOUT = 2.8 A; LLOAD 1 mH VCC - 65 VCC - 55 VCC - 45 V Table 4. Switching Symbol Parameter Test conditions Min. Typ. Max. Unit Turn-on delay on output current IOUT = 2.8 A, resistive load input rise time < 0.1 s, VCC = 24 V; TJ = 25 °C - 40 - s Rise time of output current IOUT = 2.8 A, resistive load input rise time < 0.1 s, VCC = 24 V; TJ = 25 °C - 60 - s Turn-off delay time of output current IOUT = 2.8 A, resistive load input rise time < 0.1 s, VCC = 24 V; TJ = 25 °C - 60 - s Fall time of output current IOUT = 2.8 A, resistive load input rise time < 0.1 s, VCC = 24 V; TJ = 25 °C - 25 - s dI/dt(on) Turn-on current average slope IOUT = 2.8 A, IOUT = ILIM; 25 °C < TJ < 140 °C - - 0.5 2 A/s dI/dt(off) Turn-off current average slope IOUT = 2.8 A, IOUT = ILIM; 25 °C < TJ < 140 °C - - 2 4 A/s td(ON) tr td(OFF) tf 6/15 DocID11741 Rev 3 VN540SP-E Electrical characteristics Table 5. Logical input Symbol Parameter Test conditions Min. Typ. Max. Unit VIL Input low level voltage - - - 2.0 V VIH Input high level voltage - 3.5 - - V VI(HYST) Input hysteresis voltage - - 0.5 - V Input current VIN = 30 V VIN = 2.0 V 25 - 300 - A A I/O input clamp voltage(1) IIN = 1 mA IIN = -1 mA 32 - 36 -0.7 - V V IIN VICL 1. The input voltage is internally clamped at 32 V minimum, it is possible to connect the input pins to a higher voltage via an external resistor calculate to not exceed 10 mA. Table 6. Protection and diagnostic Symbol VSTAT Parameter Test conditions Status output voltage ISTAT = 5 mA (fault condition) ISTAT = 1 mA ISTAT = -1 mA VSCL(1) Status clamp voltage Min. Typ. Max. Unit - - 1 V 32 36 -0.7 - V V - - - A ISTAT Leakage on diagnostic pin in high state VSTAT = 5 V VUSD Undervoltage shutdown - 5.0 - 8.0 V ILIM DC short-circuit current VCC = 24 V; RLOAD < 10 m 2.8 5.0 8.0 A Peak short-circuit current VCC = 24 V; VIN = 30; RLOAD < 10 m - - 4 A Delay time of current limiter - - - 100 s Thermal shutdown temperature - 150 170 - °C Thermal reset temperature - 135 155 - °C IOVPK tSC TTSD TR 1. Status determination > 100 ms after the switching edge. DocID11741 Rev 3 7/15 15 Switching characteristics 5 VN540SP-E Switching characteristics Figure 4. Switching characteristics 6 Truth table Table 7. Truth table 8/15 Conditions INPUT OUTPUT STATUS Normal operation L H L H H H Overtemperature L H L L H L Undervoltage L H L L H H Shorted load (current limitation) L H L H H H DocID11741 Rev 3 VN540SP-E 7 Test circuits and waveforms Test circuits and waveforms Figure 5. Peak short test circuit DocID11741 Rev 3 9/15 15 Test circuits and waveforms VN540SP-E Figure 6. Switching waveforms Figure 7. ILGND test configuration 10/15 DocID11741 Rev 3 VN540SP-E Test circuits and waveforms Figure 8. EAS evaluation circuit DocID11741 Rev 3 11/15 15 Package information 8 VN540SP-E Package information In order to meet environmental requirements, ST offers these devices in different grades of ECOPACK® packages, depending on their level of environmental compliance. These packages have a Lead-free second level interconnect. The category of second Level Interconnect is marked on the package and on the inner box label, in compliance with JEDEC Standard JESD97. The maximum ratings related to soldering conditions are also marked on the inner box label. ECOPACK® specifications, grade definitions and product status are available at: www.st.com. ECOPACK® is an ST trademark. 8.1 PowerSO-10 package information Figure 9. PowerSO-10 package outline 12/15 DocID11741 Rev 3 VN540SP-E Package information Table 8. PowerSO-10 package mechanical data Dimensions (mm) Dimensions (inch) Symbol Note Typ. Min. Max. Typ. Min. Max. A1 0.05 0 0.1 0.0019 0.0004 0.003 - A2 3.5 3.4 3.6 0.137 0.135 0.139 - A3 1.3 1.2 1.4 0.05 0.048 0.052 - A4 0.2 0.15 0.25 0.007 0.006 0.01 - a 0.2 - - 0.007 - - - b 0.45 0.37 0.53 0.017 0.015 0.019 - c 0.27 0.23 0.32 0.01 0.009 0.011 - D 9.5 9.4 9.6 0.374 0.372 0.377 - D1 7.5 7.4 7.6 0.295 0.292 0.298 - d 0.05 0 0.1 0.0015 0 0.0035 - E 14.1 13.85 14.35 0.555 0.547 0.562 - E1 9.4 9.3 9.5 0.37 0.367 0.372 (1) E2 7.4 7.3 7.5 0.292 0.291 0.295 - E3 6.1 5.9 6.3 0.24 0.234 0.246 - e 1.27 - - 0.05 0.048 0.051 - e1 5.08 - - 0.2 - - - F 0.5 - - 0.019 - - - G 1.2 - - 0.047 - - - L 1 0.8 1.1 0.039 0.033 0.043 - R1 - - 0.25 - - 0.01 - R2 0.8 - - 0.031 - - - T 5 deg. 2 deg. 8 deg. 5 deg. 3 deg. 7 deg. - T1 6 deg. - - 6 deg. - - - T2 10 deg. - - 10 deg. - - - 1. Resin protrusions not included (max. value: 0.15 mm per side). DocID11741 Rev 3 13/15 15 Ordering information 9 VN540SP-E Ordering information Table 9. Order codes 10 Package Tube Tape and reel PowerSO-10 VN540SP-E VN540SPTR-E Revision history Table 10. Document revision history Date Revision 2-Nov-2005 1 Initial release. 2 Removed VN540-12-E and PENTAWATT(012Y) from the whole document. Updated PTOT and EAS in Table 1 on page 3. Added Figure 8 on page 11. Updated Section 8 on page 12. Minor modifications throughout document. 3 Removed VN540-E and PENTAWATT from the whole document. Updated Section 8 Updated Figure 3 and Figure 8. 09-May-2018 05-Oct-2020 14/15 Changes DocID11741 Rev 3 VN540SP-E IMPORTANT NOTICE – PLEASE READ CAREFULLY STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order acknowledgement. Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or the design of Purchasers’ products. No license, express or implied, to any intellectual property right is granted by ST herein. Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST for such product. ST and the ST logo are trademarks of ST. All other product or service names are the property of their respective owners. Information in this document supersedes and replaces information previously supplied in any prior versions of this document. © 2020 STMicroelectronics – All rights reserved DocID11741 Rev 3 15/15 15