VNQ690SP-E

VNQ690SP-E QUAD CHANNEL HIGH SIDE DRIVER Table 1. General Features Type VNQ690SP-E RDS(on) 90mΩ (*) Figure 1. Package Iout 10A VCC 36V (*) Per each channel s OUTPUT CURRENT PER CHANNEL: 10A s CMOS COMPATIBLE INPUTS s OPEN LOAD DETECTION (OFF STATE) s UNDERVOLTAGE & OVERVOLTAGE n SHUT- DOWN s OVERVOLTAGE CLAMP s THERMAL SHUT-DOWN s CURRENT LIMITATION s VERY LOW STAND-BY POWER DISSIPATION s PROTECTION AGAINST: n LOSS OF GROUND & LOSS OF VCC s REVERSE BATTERY PROTECTION (**) s IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE 10 1 PowerSO-10 ™ DESCRIPTION The VNQ690SP-E is a monolithic device made by using| STMicroelectronics VIPower M0-3 Technology, intended for driving resistive or inductive loads with one side connected to ground. This device has four independent channels. Built-in thermal shut down and output current limitation protect the chip from over temperature and short circuit. Table 2. Order Codes Package PowerSO-10™ Note: (**) See application schematic at page 9 Tube VNQ690SP-E Tape and Reel VNQ690SPTR-E Rev. 1 October 2004 1/20 VNQ690SP-E Figure 2. Block Diagram VCC OVERVOLTAGE UNDERVOLTAGE DEMAG 1 DRIVER 1 OUTPUT 1 ILIM1 INPUT 1 INPUT 2 INPUT 3 INPUT 4 STATUS STATUS DRIVER 4 DEMAG 2 DRIVER 2 OUTPUT 2 ILIM2 LOGIC DEMAG 3 DRIVER 3 OUTPUT 3 ILIM3 DEMAG 4 OVERTEMP. 1 ILIM4 OVERTEMP. 2 OVERTEMP. 3 OVERTEMP. 4 GND OPEN LOAD OFF-STATE OUTPUT 4 Table 3. Absolute Maximum Ratings Symbol VCC Parameter Value Unit Supply voltage (continuous) Reverse supply voltage (continuous) Output current (continuous), per each channel Reverse output current (continuous), per each channel Input current Status current Ground current at TC