TLP3120(F)

TLP3120 TOSHIBA Photocoupler Photorelay TLP3120 High-Speed Memory Tester High-Speed Logic Tester High-Frequency Measurement Equipment Unit: mm The Toshiba TLP3120 consists of an infrared emitting diode optically coupled to a photo-MOSFET in a SOP, which is suitable for surface mount assembly. • 6-pin SOP (2.54SOP6): 2.1 mm high, 2.54 mm pitch • Normally opened (form A) device • Peak OFF-state voltage: 80 V (min) • Trigger LED current: 5 mA (max) • ON-state current: 1.25 A (max) • ON-state resistance: 0.15 Ω (max) • Capacitance between output terminals: 1000 pF (max) • Isolation voltage: 1500 Vrms (min) • UL-recognized: UL 1577, File No.E67349 • cUL-recognized: CSA Component Acceptance Service No.5A File No.E67349 TOSHIBA 11-7C1 Weight: 0.13 g (typ.) Pin Configuration (top view) 1 6 2 5 3 4 1: 2: 3: 4: 5: 6: Anode Cathode N.C. Drain D1 Source Drain D2 Start of commercial production 2000-12 © 2019 Toshiba Electronic Devices & Storage Corporation 1 2019-06-17 TLP3120 Absolute Maximum Ratings (Ta = 25°C) Characteristics Symbol Rating Unit IF 50 mA ΔIF/°C -0.5 mA/°C VR 5 V Forward current Led Forward current derating (Ta ≥ 25°C) Reverse voltage PD 50 mW ΔPD /°C -0.5 mW/°C Tj 125 °C VOFF 80 V ION 1.25 A ΔION/°C -12.5 mA/°C PO 234 mW ΔPO / °C -2.34 mW / °C Tj 125 °C Storage temperature range Tstg -40 to 125 °C Operating temperature range Topr -20 to 85 °C Lead soldering temperature (10 s) Tsol 260 °C Isolation voltage (AC, 60 s, R.H. ≤ 60 %) (Note 1) BVS 1500 Vrms Diode power dissipation Diode power dissipation derating (Ta ≥25°C) Junction temperature OFF-state output terminal voltage Detector ON-state current ON-state current derating (Ta ≥ 25°C) Output power dissipation Output power dissipation derating (Ta ≥ 25°C) Junction temperature Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: Device is considered as a two-terminal device. LED side pins are shorted together and detector side pins are shorted together. Recommended Operating Conditions Characteristics Supply voltage Symbol Min Typ. Max Unit VDD ― ― 64 V Forward current IF 5 ― 30 mA ON-state current ION ― ― 1.25 A Operating temperature Topr 25 ― 60 °C Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the device. Additionally, each item is an independent guideline respectively. In developing designs using this product, please confirm specified characteristics shown in this document. Individual Electrical Characteristics (Ta = 25°C) Detector LED Characteristics Symbol Test Condition Min Typ. Max Unit Forward current VF IF = 10 mA 1.0 1.15 1.3 V Reverse current IR VR = 5 V ― ― 10 μA Capacitance between terminals CT VF = 0 V, f = 1 MHz ― 15 ― pF OFF-state current IOFF VOFF = 20 V, Ta = 50 °C ― 1200 1500 pA Capacitance between terminals COFF V = 0 V, f = 100 MHz ― 460 1000 pF © 2019 Toshiba Electronic Devices & Storage Corporation 2 2019-06-17 TLP3120 Coupled Electrical Characteristics (Ta = 25°C) Characteristics Symbol Test Condition Min Typ. Max Unit Trigger LED current IFT ION = 1.25 A ― 2 5 mA Return LED current IFC IOFF = 10 μA 0.2 ― ― mA ON-state resistance RON ION = 1.25 A, IF = 5 mA ― 0.11 0.15 Ω Min Typ. Max Unit ― 0.8 ― pF 5 × 1010 1014 ― Ω 1500 ― ― Vrms Min Typ. Max Unit ― 2.0 3.0 ― 0.7 1.0 Isolation Characteristics (Ta = 25°C) Characteristics Symbol Test Condition Capacitance input to output CS VS = 0 V, f = 1 MHz Isolation resistance RS VS = 500 V, R.H. ≤ 60 % Isolation voltage BVS AC, 60 s Switching Characteristics (Ta = 25°C) Characteristics Symbol Test Condition Turn-ON time tON RL = 200 Ω Turn-OFF time tOFF VDD = 20 V, IF = 5 mA (Note 2) ms Note 2: Switching time test circuit IF 1 6 RL 2 VDD IF VOUT VOUT 4 tON © 2019 Toshiba Electronic Devices & Storage Corporation 90% 10% 3 tOFF 2019-06-17 TLP3120 IF – Ta ION – Ta (mA) 1500 Allowable ON-state current Allowable forward current 1250 ION 80 IF (mA) 100 60 40 20 0 −20 0 20 40 60 80 100 1000 750 500 250 0 −20 120 0 20 Ambient temperature Ta (°C) 40 50 (mA) ION 10 5 ON-state current Forward current IF (mA) 30 3 1 0.5 0.3 0.8 1 1.2 Forward voltage 1.4 VF 1.6 1000 IF = 5 mA 500 0 −500 −1000 −0.2 (V) 0 ION = 1250 mA (mA) IF = 5 mA IFT Trigger LED current (Ω) RON ON-state resistance (V) IFT – Ta t < 1s 0.06 0.05 0.04 0.03 −20 0.4 5 ION = 1250 mA 0.07 0.2 ON-state voltage VON RON – Ta 0.08 120 Ta = 25°C −1500 −0.4 1.8 0.10 0.09 100 ION – VON 1500 Ta = 25°C 0.1 0.6 80 Ambient temperature Ta (°C) I F – VF 100 60 0 20 40 60 Ambient temperature Ta (°C) 80 100 t < 1s 4 3 2 1 0 −20 0 20 40 60 80 100 Ambient temperature Ta (°C) NOTE: The above characteristics curves are presented for reference only and not guaranteed by production test, unless otherwise noted. © 2019 4 2019-06-17 Toshiba Electronic Devices & Storage Corporation TLP3120 tON, tOFF – IF tON, tOFF – Ta 3000 3000 Ta = 25°C RL = 200 Ω tON, tOFF 1000 500 300 tOFF 100 50 3 5 10 30 Forward current 50 IF 100 tON (μs) VDD = 20 V Switching time Switching time tON, tOFF (μs) tON 1000 500 300 tOFF 100 50 −20 300 VDD = 20 V RL = 200 Ω IF = 5 mA 0 20 40 60 80 100 Ambient temperature Ta (°C) (mA) IOFF – Ta (nA) 1 OFF-state current 3 IOFF 10 0.3 VOFF = 80 V 0.1 VOFF = 50 V 3 VOFF = 20 V 0.03 0.01 −20 0 20 40 60 80 100 Ambient temperature Ta (°C) NOTE: The above characteristics curves are presented for reference only and not guaranteed by production test, unless otherwise noted. © 2019 Toshiba Electronic Devices & Storage Corporation 5 2019-06-17 TLP3120 RESTRICTIONS ON PRODUCT USE Toshiba Corporation and its subsidiaries and affiliates are collectively referred to as “TOSHIBA”. Hardware, software and systems described in this document are collectively referred to as “Product”. • TOSHIBA reserves the right to make changes to the information in this document and related Product without notice. • This document and any information herein may not be reproduced without prior written permission from TOSHIBA. Even with TOSHIBA's written permission, reproduction is permissible only if reproduction is without alteration/omission. • Though TOSHIBA works continually to improve Product's quality and reliability, Product can malfunction or fail. Customers are responsible for complying with safety standards and for providing adequate designs and safeguards for their hardware, software and systems which minimize risk and avoid situations in which a malfunction or failure of Product could cause loss of human life, bodily injury or damage to property, including data loss or corruption. Before customers use the Product, create designs including the Product, or incorporate the Product into their own applications, customers must also refer to and comply with (a) the latest versions of all relevant TOSHIBA information, including without limitation, this document, the specifications, the data sheets and application notes for Product and the precautions and conditions set forth in the "TOSHIBA Semiconductor Reliability Handbook" and (b) the instructions for the application with which the Product will be used with or for. Customers are solely responsible for all aspects of their own product design or applications, including but not limited to (a) determining the appropriateness of the use of this Product in such design or applications; (b) evaluating and determining the applicability of any information contained in this document, or in charts, diagrams, programs, algorithms, sample application circuits, or any other referenced documents; and (c) validating all operating parameters for such designs and applications. TOSHIBA ASSUMES NO LIABILITY FOR CUSTOMERS' PRODUCT DESIGN OR APPLICATIONS. • PRODUCT IS NEITHER INTENDED NOR WARRANTED FOR USE IN EQUIPMENTS OR SYSTEMS THAT REQUIRE EXTRAORDINARILY HIGH LEVELS OF QUALITY AND/OR RELIABILITY, AND/OR A MALFUNCTION OR FAILURE OF WHICH MAY CAUSE LOSS OF HUMAN LIFE, BODILY INJURY, SERIOUS PROPERTY DAMAGE AND/OR SERIOUS PUBLIC IMPACT ("UNINTENDED USE"). Except for specific applications as expressly stated in this document, Unintended Use includes, without limitation, equipment used in nuclear facilities, equipment used in the aerospace industry, lifesaving and/or life supporting medical equipment, equipment used for automobiles, trains, ships and other transportation, traffic signaling equipment, equipment used to control combustions or explosions, safety devices, elevators and escalators, and devices related to power plant. IF YOU USE PRODUCT FOR UNINTENDED USE, TOSHIBA ASSUMES NO LIABILITY FOR PRODUCT. For details, please contact your TOSHIBA sales representative or contact us via our website. • Do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy Product, whether in whole or in part. • Product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any applicable laws or regulations. • The information contained herein is presented only as guidance for Product use. No responsibility is assumed by TOSHIBA for any infringement of patents or any other intellectual property rights of third parties that may result from the use of Product. No license to any intellectual property right is granted by this document, whether express or implied, by estoppel or otherwise. • ABSENT A WRITTEN SIGNED AGREEMENT, EXCEPT AS PROVIDED IN THE RELEVANT TERMS AND CONDITIONS OF SALE FOR PRODUCT, AND TO THE MAXIMUM EXTENT ALLOWABLE BY LAW, TOSHIBA (1) ASSUMES NO LIABILITY WHATSOEVER, INCLUDING WITHOUT LIMITATION, INDIRECT, CONSEQUENTIAL, SPECIAL, OR INCIDENTAL DAMAGES OR LOSS, INCLUDING WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF OPPORTUNITIES, BUSINESS INTERRUPTION AND LOSS OF DATA, AND (2) DISCLAIMS ANY AND ALL EXPRESS OR IMPLIED WARRANTIES AND CONDITIONS RELATED TO SALE, USE OF PRODUCT, OR INFORMATION, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, ACCURACY OF INFORMATION, OR NONINFRINGEMENT. • GaAs (Gallium Arsenide) is used in Product. GaAs is harmful to humans if consumed or absorbed, whether in the form of dust or vapor. Handle with care and do not break, cut, crush, grind, dissolve chemically or otherwise expose GaAs in Product. • Do not use or otherwise make available Product or related software or technology for any military purposes, including without limitation, for the design, development, use, stockpiling or manufacturing of nuclear, chemical, or biological weapons or missile technology products (mass destruction weapons). Product and related software and technology may be controlled under the applicable export laws and regulations including, without limitation, the Japanese Foreign Exchange and Foreign Trade Law and the U.S. Export Administration Regulations. Export and re-export of Product or related software or technology are strictly prohibited except in compliance with all applicable export laws and regulations. • Please contact your TOSHIBA sales representative for details as to environmental matters such as the RoHS compatibility of Product. Please use Product in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances, including without limitation, the EU RoHS Directive. TOSHIBA ASSUMES NO LIABILITY FOR DAMAGES OR LOSSES OCCURRING AS A RESULT OF NONCOMPLIANCE WITH APPLICABLE LAWS AND REGULATIONS. https://toshiba.semicon-storage.com/ © 2019 Toshiba Electronic Devices & Storage Corporation 6 2019-06-17