OX-0421-BET-108

Oven Controlled Crystal Oscillator OX-042 OX-042 Features • Low G-Sensitivity • Low Phase Noise • High Stability • SC-Cut Crystal Standard • Vectron’s Patented (US Patent 6,984,925) QRM Crystal Technology • Frequency Range: 3 MHZ to 20 MHZ • • • • • • Applications Military Radar Test Equipment Frequency Synthesizers Position Location Satellite Communications Performance Specifications Parameter With Standard Crystals With QRM Crystals Min 3 8 Typ Max 20 15 Units MHz MHz Condition Available Frequencies G-Sensitivity Performance G Sensitivity w\QRM crystal ≥ 10 MHz G Sensitivity w\std. crystal ≥ 10 MHz (No mechanical resonances out to 2KHz) 0.2 2.0 ppb/g ppb/g Degrades to 0.4 ppb/g @ 8 MHz Degrades to 4.0 ppb/g @ 3 MHz G sensitivity specified as Total Gamma Frequency Stabilities1 vs. operating temperature range (referenced to +25°C) -30 -25 -20 -10 -100 -2.0 -2.0 -0.3 -50 -30 +30 +25 +20 +10 +100 +2.0 +2.0 +0.3 +50 +30 5 ppb ppb ppb ppb ppb ppb ppb ppb ppb ppb minutes -40… +85°C -40… +70°C -20… +70°C 0… +70°C at time of shipment, nominal EFC Vs ± 5% Load ± 5% after 72 hours of operation after 72 hours of operation to ± 10ppb of final frequency (1 hour reading) @ +25°C Initial Tolerance vs. supply voltage change vs. load change vs. aging / daily vs. aging / 1 year vs. aging / year (following years) Warm-up Time Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com Performance Specifications Parameter Supply voltage (Standard-Opt A) Supply voltage (Standard-Opt B) Oven Power Consumption Min 14.25 11.4 Typ 15.0 12.0 Max 15.75 12.6 6.0 3.0 Units VDC VDC Watts Watts Condition 18 & 24 VDC options available 18 & 24 VDC options available during warm-up steady state @ +25°C Supply Voltage (Vs) RF Output Signal Load Output Power Harmonics Tuning Range Tuning Range Linearity Tuning Slope Control Voltage Range Phase Noise3 (@5 MHZ) (under static conditions - no vibration) 0.0 2.5 ±0.75 ±0.2 ±1.0 ±0.5 +7.0 -30 ±2.0 ±1.0 20 Positive 5.0 VDC Sinewave 50 ohm dBm dBc ppm ppm % 50 ohm load 50 ohm load Internal mechanical Electronic frequency control Frequency Tuning (Internal Mechanical) Frequency Tuning (EFC - optional) Additional Parameters1 -115 -140 -155 -166 -168 -100 -133 -155 -166 -168 -105 -137 -152 -163 -165 -95 -127 -152 -163 -165 100 28 short -55 -55 open +85 +125 dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz g VDC ohm °C °C 1 Hz 10 Hz 100 Hz 1 KHz 10 KHz 1 Hz 10 Hz 100 Hz 1 KHz 10 KHz Phase Noise3 (@ 10 MHZ) (under static conditions - no vibration) Weight Supply voltage (Vs) Output Load Operable temperature range Storage temperature range Shock - operating Shock - endurance Sine Vibration - operating Sine Vibration - endurance Random Vibration - operating Random Vibration - endurance Seal Absolute Maximum Ratings Environmental Specifications Mil-STD-202, Method 213, Condition J, 30G, 11 ms half-sine impulse Mil-STD-202, Method 213, Condition C, 100G, 11 ms half-sine impulse Mil-STD-202, Method 204, Condition C, 10 G to 2 kHz Mil-STD-202, Method 204, Condition D, 20 G to 2 kHz Mil-STD-202, Method 214, Condition C, 10.7 Grms to 2 kHz Mil-STD-202, Method 214, Condition H, 34 Grms to 2 kHz Mil-STD-202, Method 112, Condition D (not applicable to units with SMA connector) Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com Outline Drawing / Enclosure Dimensions in inches Type A Code 0 1 Height “H” max 1.04 0.80 Pin Connections 1 2 3 4 5 Electronic Frequency Control (EFC) (optional) No Connection RF Output Ground (Case) Supply Voltage Input (Vs) Dimensions in inches Type B Code 2 Height “H” max 1.04 Pin Connections 1 2 3 Supply Voltage Input (Vs) Ground (Case) Electronic Frequency Control (EFC) (optional) Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com Ordering Information OX - 042 0 - A E T-108 Product Family OX: OCXO Package 50 x 50 mm Configuration\Height 0: A1.04 inches 1: A0.80 inches 2: B1.04 inches 0 - 10M0000000 Frequency Platform Code Low G, EFC option 0: Std Crystal, No EFC 1: Low G-QRM Crystal, No EFC 2: Std Crystal, w\EFC 3: Low G-QRM Crystal, w\EFC Temperature Range / Stability Code E-308: -40°C to +85°C, ±30ppb D-258: -40°C to +70°C, ±25ppb J-208: -20°C to +70°C, ±20ppb T-108: 0°C to +70°C, ±10ppb Supply Voltage A: 15 Vdc B: 12 Vdc RF Output Code E: Sinewave Notes: 1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all frequencies. 2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency control voltage, load, temperature (25°C). 3. Phase noise degrades with increasing output frequency. 4. Subject to technical modification. 5. Contact factory for availability. For Additional Information, Please Contact Vectron International 267 Lowell Road Hudson, NH 03051 Tel: 1.888.328.7661 Fax: 1.888.329.8328 USA: Vectron International Landstrasse, D-74924 Neckarbischofsheim, Germany Tel: +49 (0) 3328.4784.17 Fax: +49 (0) 3328.4784.30 Europe: Vectron International 1F-2F, No 8 Workshop, No 308 Fenju Road WaiGaoQiao Free Trade Zone Pudong, Shanghai, China 200131 Tel: 86.21.5048.0777 Fax: 86.21.5048.1881 Asia: Disclaimer Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Rev: 8/18/2009 daf Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com