6EP1333-2BA20

Data sheet 6EP1333-2BA20 SITOP PSU100S/1AC/24VDC/5A SITOP PSU100S 24 V/5 A Stabilized power supply input: 120/230 V AC, output: 24 V DC/5 A *Ex approval no longer available* Input Input ● Note 1-phase AC Automatic range selection supply voltage ● 1 at AC rated value 120 V ● 2 at AC rated value 230 V input voltage ● 1 at AC 85 ... 132 V ● 2 at AC 170 ... 264 V Wide-range input No Overvoltage resistance 2.3 × Vin rated, 1.3 ms Mains buffering at Vin = 93/187 V Mains buffering at Iout rated, min. 20 ms; at Vin = 93/187 V Rated line frequency 1 50 Hz Rated line frequency 2 60 Hz Rated line range 47 ... 63 Hz input current ● at rated input voltage 120 V 2.34 A ● at rated input voltage 230 V 1.36 A Switch-on current limiting (+25 °C), max. 40 A I²t, max. 1 A²·s Built-in incoming fuse T 3,15 A/250 V (not accessible) Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: from 6 A characteristic C Output Output Controlled, isolated DC voltage Rated voltage Vout DC 24 V ● output voltage at output 1 at DC rated value 24 V Total tolerance, static ± 3% Static mains compensation, approx. 0.1 % Static load balancing, approx. 1% Residual ripple peak-peak, max. 150 mV Residual ripple peak-peak, typ. 30 mV Spikes peak-peak, max. (bandwidth: 20 MHz) 240 mV Spikes peak-peak, typ. (bandwidth: 20 MHz) 140 mV Adjustment range 22.8 ... 28 V product function output voltage adjustable Yes Output voltage setting via potentiometer Status display Green LED for 24 V OK Signaling Relay contact (NO contact, rating 60 V DC/ 0.3 A) for "24 V OK" 6EP13332BA20 Page 1/3 2/16/2022 Subject to change without notice © Copyright Siemens On/off behavior Overshoot of Vout < 3 % Startup delay, max. 0.3 s Voltage rise, typ. 15 ms Rated current value Iout rated 5A Current range 0 ... 6 A ● Note supplied active power typical 6 A up to +45°C; +60 ... +70 °C: Derating 1.6%/K 144 W short-term overload current ● on short-circuiting during the start-up typical 18 A ● at short-circuit during operation typical 18 A duration of overloading capability for excess current ● on short-circuiting during the start-up 800 ms ● at short-circuit during operation 800 ms Parallel switching for enhanced performance Yes Numbers of parallel switchable units for enhanced performance 2 Efficiency Efficiency at Vout rated, Iout rated, approx. 88 % Power loss at Vout rated, Iout rated, approx. 16 W Closed-loop control Dynamic mains compensation (Vin rated ±15 %), max. 0.3 % Dynamic load smoothing (Iout: 10/90/10 %), Uout ± typ. 3% Load step setting time 10 to 90%, typ. 1 ms Load step setting time 90 to 10%, typ. 1 ms Protection and monitoring Output overvoltage protection protection against overvoltage in case of internal fault Vout < 33 V Current limitation 6 ... 7.1 A property of the output short-circuit proof Yes Short-circuit protection Constant current characteristic enduring short circuit current RMS value ● typical 7.1 A overcurrent overload capability in normal operation overload capability 150 % Iout rated up to 5 s/min Overload/short-circuit indicator - Safety Primary/secondary isolation Yes galvanic isolation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 Protection class Class I leakage current ● maximum 3.5 mA ● typical 0.4 mA Degree of protection (EN 60529) IP20 Approvals CE mark Yes UL/CSA approval Yes; cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259; cCSAus (CSA C22.2 No. 60950-1, UL 60950-1) UL/CSA approval Yes; cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259, cCSAus (CSA C22.2 No. 60950-1, UL 60950-1) certificate of suitability cCSAus, Class 1, Division 2 No certificate of suitability ATEX No certificate of suitability ● IECEx No ● NEC Class 2 No ● ULhazloc approval No FM approval No CB approval Yes certificate of suitability ● EAC approval Yes Marine approval Yes Marine approval BV, DNV GL Marine classification association American Bureau of No 6EP13332BA20 Page 2/3 2/16/2022 Subject to change without notice © Copyright Siemens Shipping Europe Ltd. (ABS) Marine classification association French marine classification society (BV) Yes Marine classification association DNV GL Yes Marine classification association Lloyds Register of Shipping (LRS) No Marine classification association Nippon Kaiji Kyokai (NK) No EMC Emitted interference EN 55022 Class B Supply harmonics limitation EN 61000-3-2 Noise immunity EN 61000-6-2 environmental conditions ambient temperature ● during operation — Note -25 ... +70 °C with natural convection ● during transport -40 ... +85 °C ● during storage -40 ... +85 °C Humidity class according to EN 60721 Climate class 3K3, 5 … 95% no condensation Mechanics Connection technology screw-type terminals Connections ● Supply input L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm² single-core/finely stranded ● Output +, -: 2 screw terminals each for 0.5 ... 2.5 mm² ● Auxiliary Alarm signals: 2 screw terminals for 0.5 ... 2.5 mm² ● signaling contact 2 screw terminals for 0.5 ... 2.5 mm² width of the enclosure 50 mm height of the enclosure 125 mm depth of the enclosure 120 mm required spacing ● top 50 mm ● bottom 50 mm ● left 0 mm ● right 0 mm Weight, approx. 0.5 kg product feature of the enclosure housing can be lined up Yes Installation Snaps onto DIN rail EN 60715 35x7.5/15 electrical accessories Buffer module mechanical accessories Device identification label 20 mm × 7 mm, pale turquoise 3RT19001SB20 MTBF at 40 °C 1 998 441 h other information Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified) 6EP13332BA20 Page 3/3 2/16/2022 Subject to change without notice © Copyright Siemens