6ES7155-6AU01-0BN0.

Data sheet 6ES7155-6AU01-0BN0 SIMATIC ET 200SP, PROFINET interface module IM 155-6PN Standard, max. 32 I/O modules, and 16 ET 200AL modules, single hot swap, incl. server module (6ES7193-6PA00-0AA0) General information Product type designation IM 155-6 PN ST HW functional status From FS03 Firmware version V4.2 ● FW update possible Yes Product function ● I&M data Yes; I&M0 to I&M3 ● Module swapping during operation (hot swapping) Yes; Single hot swapping ● Isochronous mode No Engineering with ● STEP 7 TIA Portal configurable/integrated from version V14 ● STEP 7 configurable/integrated from version V5.5 SP4 ● PROFINET from GSD version/GSD revision GSDML V2.35 Configuration control via dataset Yes Supply voltage Rated value (DC) 24 V permissible range, lower limit (DC) 19.2 V permissible range, upper limit (DC) 28.8 V Reverse polarity protection Yes Short-circuit protection Yes Mains buffering ● Mains/voltage failure stored energy time 10 ms Input current Current consumption (rated value) 450 mA Current consumption, max. 550 mA Inrush current, max. 3.7 A I²t 0.09 A²·s Power loss Power loss, typ. 1.9 W Address area Address space per module ● Address space per module, max. 256 byte; For input and output data respectively Address space per station ● Address space per station, max. 512 byte Hardware configuration Rack ● Quantity of operable ET 200SP modules, max. 32 ● Quantity of operable ET 200AL modules, max. 16 Submodules 6ES71556AU010BN0 Page 1/3 5/22/2024 Subject to change without notice © Copyright Siemens ● Number of submodules per station, max. 256 Interfaces Number of PROFINET interfaces 1; 2 ports (switch) 1. Interface Interface types ● RJ 45 (Ethernet) Yes ● Number of ports 2 ● integrated switch Yes ● BusAdapter (PROFINET) Yes; BA 2x RJ45, BA 2x FC, BA 2x M12 Protocols ● PROFINET IO Device Yes ● Open IE communication Yes ● Media redundancy Yes; PROFINET MRP PROFINET IO Device Services — IRT Yes; 250 µs to 4 ms in 125 µs frame — PROFIenergy Yes — Prioritized startup Yes — Shared device Yes — Number of IO Controllers with shared device, max. 2 Interface types RJ 45 (Ethernet) ● Transmission procedure PROFINET with 100 Mbit/s full duplex (100BASE-TX) ● 100 Mbps Yes ● Autonegotiation Yes ● Autocrossing Yes Protocols Modbus TCP No Redundancy mode ● PROFINET system redundancy (S2) No Media redundancy — MRP Yes — MRPD No Open IE communication ● TCP/IP Yes ● SNMP Yes ● LLDP Yes Interrupts/diagnostics/status information Status indicator Yes Alarms Yes Diagnostics function Yes Diagnostics indication LED ● RUN LED Yes; green LED ● ERROR LED Yes; red LED ● MAINT LED Yes; Yellow LED ● Monitoring of the supply voltage (PWR-LED) Yes; green PWR LED ● Connection display LINK TX/RX Yes; 2x green link LEDs on BusAdapter Potential separation between backplane bus and electronics No between PROFINET and all other circuits Yes; 1500 V AC (type test) between supply and all other circuits No Permissible potential difference between different circuits Safety extra low voltage SELV Isolation Isolation tested with 707 V DC (type test) Standards, approvals, certificates Network loading class 2 Ambient conditions Ambient temperature during operation ● horizontal installation, min. 6ES71556AU010BN0 Page 2/3 -30 °C; No condensation 5/22/2024 Subject to change without notice © Copyright Siemens ● horizontal installation, max. 60 °C ● vertical installation, min. -30 °C; No condensation ● vertical installation, max. 50 °C Altitude during operation relating to sea level ● Installation altitude above sea level, max. 5 000 m; Restrictions for installation altitudes > 2 000 m, see manual connection method ET-Connection ● via BU/BA Send Yes; + 16 ET 200AL modules Dimensions Width 50 mm Height 117 mm Depth 74 mm Weights Weight, approx. 147 g; without BusAdapter last modified: 5/22/2024 6ES71556AU010BN0 Page 3/3 5/22/2024 Subject to change without notice © Copyright Siemens