TLP541G

TLP541G, TLP542G TOSHIBA Photocoupler GaAs Ired & Photo-Thyristor TLP541G,TLP542G Programmable Controllers AC−Output Module Solid State Relay The TOSHIBA TLP541G consists of a photo−thyristor optically coupled to a gallium arsenide infrared emitting diode in a six lead plastic DIP package. The TOSHIBA TLP542G consists of a photo−thyristor optically coupled to a gallium arsenide infrared emitting diode in a seven lead plastic DIP package. • • • • • Peak off-state voltage: 400 V (min.) Trigger LED current: 7 mA (max.) On-state current: 150 mA (max.) Isolation voltage: 2500 Vrms (min.) UL recognized: UL1577, file no. E67349 Unit in mm Pin Configuration (top view) TOSHIBA Weight: 0.4 g 11−7A8 TOSHIBA Weight: 0.53 g 11−10C5 1 2002-09-25 TLP541G, TLP542G Maximum Ratings (Ta = 25°C) Characteristic Forward current Forward current derating (Ta ≥ 25°C) LED Peak forward current (100 μs pulse, 100 pps) Reverse voltage Junction temperature Peak forward voltage (RGK = 27kΩ) Peak reverse voltage (RGK = 27kΩ) Detector On−state current On−state current derating (Ta ≥ 25°C) Peak one cycle surge current Peak reverse gate voltage Junction temperature Storage temperature range Operating temperature range Lead soldering temperature (10 s) Isolation voltage (AC, 1 min., R.H. ≤ 60%) (Note) Symbol IF ΔIF / °C IFP VR Tj VDRM VRRM IT (RMS) ΔIT / °C ITSM VGM Tj Tstg Topr Tsol BVS Rating 70 −0.7 1 5 125 400 400 150 −2.0 2 −5 100 −55~125 −30~100 260 2500 Unit mA mA / °C A V °C V V mA mA / °C A V °C °C °C °C Vrms (Note) Device considered a two terminal device: LED side pins shorted together and detector side pins shorted together. Recommended Operating Conditions Characteristic Supply voltage Forward current Operating temperature Gate to cathode resistance Gate to cathode capacity Symbol VAC IF Topr RGK CGK Min. ― 10 −30 ― ― Typ. ― 16 ― 27 0.01 Max. 120 25 85 33 0.1 Unit Vac mA °C kΩ μF 2 2002-09-25 TLP541G, TLP542G Individual Electrical Characteristics (Ta = 25°C) Characteristic Forward voltage LED Reverse current Capacitance Off−state current Symbol VF IR CT IDRM Test Condition IF = 10 mA VR = 5 V V = 0, f = 1 MHz VAK = 400 V RGK = 27 kΩ VKA = 400 V RGK = 27 kΩ ITM = 100 mA RGK = 27 kΩ VAK = 280 V, RGK = 27 kΩ V = 0, f = 1 MHz Anode to gate Gate to cathode Ta = 25°C Ta = 100°C Ta = 25°C Ta = 100°C Min. 1.0 ― ― ― ― ― ― ― ― 5 ― ― Typ. 1.15 ― 30 10 1 10 1 0.9 0.2 10 20 350 Max. 1.3 10 ― 5000 100 5000 100 1.3 1 ― ― ― Unit V μA pF nA μA nA μA V mA V/μs pF Reverse current Detector On−state voltage Holding current Off−state dv/dt Capacitance IRRM VTM IH dv/dt Cj Coupled Characteristics (Ta = 25°C) Characteristic Trigger LED current Turn−on time Capacitance (input to output) Isolation resistance Isolation voltage Symbol IFT ton CS RS BVS Test Condition VAK = 6 V, RGK = 27 kΩ IF = 50 mA, RGK = 27 kΩ VS = 0, f = 1 MHz VS = 500 V, R.H. ≤ 60% AC, 1 minute Min. 1 ― ― ― 2500 Typ. 4 10 0.8 10 11 Max. 7 ― ― ― ― Unit mA μs pF Ω Vrms ― 3 2002-09-25 TLP541G, TLP542G 4 2002-09-25 TLP541G, TLP542G 5 2002-09-25 TLP541G, TLP542G RESTRICTIONS ON PRODUCT USE • The information contained herein is subject to change without notice. 20070701-EN • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer’s own risk. • The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. • GaAs(Gallium Arsenide) is used in this product. The dust or vapor is harmful to the human body. Do not break, cut, crush or dissolve chemically. • Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations. 6 2002-09-25