CY5676

CY5676 PROCTM BLE 256K MODULE CY5676 PRoCTM BLE 256K Module is a complete solution to add BLE connectivity to any embedded system. The module features a PRoC BLE device (CYBL10573) with 256 KB internal flash, 24-MHz and 32.768-kHz crystals, a PCB antenna, and other passives while providing access to all GPIOs of the device. For more information on Cypress’s BLE solutions visit www.cypress.com/BLE PRoC BLE is a single-chip solution with a 48-MHz ARM® Cortex®-M0 CPU, BLE radio, CapSense® technology for touch-sensing, two serial communication blocks (SCBs), a 12-bit ADC, four Timer/Counter/PWMs, four additional PWMs, I2S for digital audio, and segment LCD direct-drive capability. Antenna matching network (AMN) Wiggle antenna Ctank Cmod 24-MHz crystal P0_1 P0_3 P0_5 P1_0 P1_2 P0_6 P0_7 XRES GND VDDD GND P3_6 P3_4 P3_2 P3_0 P4_0 P4_1 P2_6 P2_4 P2_2 P2_0 VDDR P0_0 P0_2 P0_4 VREF P1_1 P1_4 P1_3 P1_5 P1_7 P1_6 CYBL10573-56LQXI PRoC BLE device VDD GND P1_5 P1_4 SAR bypass capacitor (bottom side) VDDA P3_7 P3_5 P3_3 P3_1 P5_1 P5_0 P2_7 P2_5 P2_3 P2_1 GND 32.768-kHz crystal (bottom side) 4-pin UART header Fig-1: Pinout Description for PRoC BLE Module Note: To apply power to the module, use the VDD pin (1.9 V - 5.0 V) and GND pin. CY5676 PROCTM BLE 256K MODULE STANDALONE USE WITH PSOC CREATORTM IDE AND CY8CKIT-002 MINIPROG3 Step 1: Select the 5-pin connector setting in PSoC Creator or PSoC Programmer. Step 2: Use 0.1” male headers (not included) or jumper wires to connect the MiniProg3 to the module. Pin Mapping CY8CKIT-002 VTARG CY5676 VDD GND GND RES XRES SCLK P0_7 SDAT P0_6 Fig-2: Programming and Debugging with CY8CKIT-002 MiniProg3 USING THE PROC BLE MODULE WITH THE CY8CKIT-042-BLE PIONEER KIT Step 1: Plug the module on the CY8CKIT-042-BLE Pioneer Kit Baseboard. Step 2: Create your design in PSoC Creator IDE and use the BLE Pioneer Kit to program and debug. Fig-3: Programming and Debugging with CY8CKIT-042-BLE Pioneer Baseboard The CY5676 module is intended to be used for evaluation of hardware and software in a laboratory environment. This module radiates radio frequency energy and has not been tested for compliance with limits applicable under any standard. Operation of this module may cause interference with radio communications. Cypress recommends that the module should only be used in a shielded room. Contact support@cypress.com for details. For more information about this kit, visit www.cypress.com/CY5676 © 2015 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. 001-97334 Rev.**