MBRF30100CTP

e athode Schottky Barrier Rectifier MBRF30100CTP, 2x 15A, 100V, ITO-220AB, Common Cathode MBRF30100CTP Pb RoHS Description Littelfuse MBR series Schottky Barrier Rectifier is designed to meet the general requirements of commercial applications by providing high temperature, low leakage and low VF products. It is suitable for high frequency switching mode power supply, free-wheeling diodes and polarity protection diodes. Features • H  igh junction temperature capability Pin out Heat sink • H  igh frequency operation • Common  cathode configuration in electrically isolated ITO220AB package • G  uard ring for enhanced ruggedness and long term reliability Common Cathode • Low forward voltage drop 1 3 2 1 Anode Common Anode Cathode 2 Applications 3 • S  witching mode power supply Anode Common Anode Cathode Pinout 2 TO-220AB Common Cathode • DC/DC converters • Polarity protection diodes • Free-wheeling diodes Maximum Ratings Pinout 3 ITO-220AB Common Cathode Parameters Heat sink Peak Inverse Voltage Symbol Test Conditions Max Unit V VRWM - 100 Average Forward Current IF(AV) 50% duty cycle @TC = 133°C, rectangular wave form 15 (per leg) 30 (total device) Peak Repetitive Forward Current(per leg) IFRM Rated VR square wave, 20KHz TC = 133°C 20 A Peak One Cycle Non-Repetitive Surge Cathode Anode Current (per leg) IFSM Surge applied at rated load conditions halfwave, single phase,60Hz 150 A Symbol Test Conditions Max VF1 @ 15A, Pulse, TJ = 25 °C 0.85 VF2 @ 15A, Pulse, TJ = 125 °C 0.70 Cathode 1 2 A Pinout 5 TO-220AC Electrical Characteristics Parameters Forward Voltage Drop (per leg) * Reverse Current (per leg) * IR1 @VR = rated VR TJ = 25 °C 1.0 IR2 @VR = rated VR TJ = 125 °C 6.0 Unit V mA Junction Capacitance (per leg) CT @VR = 5V, TC = 25 °C fSIG = 1MHz 400 pF Typical Series Inductance (per leg) LS Measured lead to lead 5 mm from package body 8.0 nH Voltage Rate of Change dv/dt 10,000 V/μs RSM Isolation Voltage (t = 1.0 second, R. H. < =30%, TA = 25 °C) VISO Clip mounting, the epoxy body away from the heatsink edge by more than 0.110” along the lead direction. 4500 Clip mounting, the epoxy body is inside the heatsink. 3500 Screw mounting, the epoxy body is inside the heatsink. 1500 V * Pulse Width < 300μs, Duty Cycle