TLP224G

TLP224G,TLP224G-2 TOSHIBA Photocoupler Photorelay TLP224G,TLP224G-2 Modems PBX Telecommunications The TOSHIBA TLP224G series consists of gallium arsenide infrared emitting diode optically coupled to a photo-MOSFET in a 4 pin DIP (DIP4), which is suitable for equipment for high tech communications, including modems. The TLP224G series complies with FCC part 68 rules with current limiting function. • • • • • • • • • TLP224G: 4 pin DIP, 1 channel type (1 form A) TLP224G-2: 8 pin DIP, 2 channel type (2 form A) Peak off-state voltage: 350 V (min) Trigger LED current: 3 mA (max) On-state current: 120 mA (max) Load current limiting: 150 mA to 300 mA (t = 5 ms) On-state resistance: 35 Ω (max) Isolation voltage: 2500 Vrms (min) UL recognized: UL1577, file No. E67349 JEDEC JEITA TOSHIBA Weight: 0.26 g (typ.) 1 form A 4 3 Unit: mm TLP224G ⎯ ⎯ 11-5B2 1 2 TLP224G-2 JEDEC JEITA TOSHIBA ⎯ ⎯ 11-10C4 Weight: 0.54 g (typ.) 2 form A 8 5 1 4 1 2007-10-01 TLP224G,TLP224G-2 Pin Configuration (top view) TLP224G 1 4 1 TLP224G-2 8 2 1: Anode 2: Cathode 3: Drain 1 4: Drain 2 3 2 7 3 6 4 1, 3: 2, 4: 5: 6: 7: 8: Anode Cathode Drain 1 Drain 2 Drain 3 Drain 4 5 Internal Circuit TLP224G 1 4 2 3 2 2007-10-01 TLP224G,TLP224G-2 Absolute Maximum Ratings (Ta = 25°C) Characteristics Forward current Forward current derating (Ta ≥ 25°C) LED Peak forward current (100 μs pulse, 100 pps) Reverse voltage Junction temperature Off-state output terminal voltage On-state current Detector (Note 1) Symbol IF ΔIF/°C IFP VR Tj VOFF ION ΔION/°C Tj Tstg Topr Tsol BVS Rating 50 −0.5 1 6 125 350 120 −1.2 125 −55 to 125 −40 to 85 260 2500 Unit mA mA/°C A V °C V mA mA/°C °C °C °C °C Vrms On-state current derating (Ta ≥ 25°C) (Note 1) Junction temperature Storage temperature range Operating temperature range Lead soldering temperature (10 s) Isolation voltage (AC, 1 min., R.H. ≤ 60%) (Note 2) Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: Two channels operating simultaneously. Note 2: Device considered a two-terminal device: LED side pins shorted together, and detector side pins shored together. Recommended Operating Conditions Characteristics Supply voltage Forward current On-state current Operating temperature Symbol VDD IF ION Topr Min ⎯ 5 ⎯ −20 Typ. ⎯ 7.5 ⎯ ⎯ Max 280 25 100 65 Unit V mA mA °C Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the device. Additionally, each item is an independent guideline respectively. In developing designs using this product, please confirm specified characteristics shown in this document. 3 2007-10-01 TLP224G,TLP224G-2 Individual Electrical Characteristics (Ta = 25°C) Characteristics Forward voltage LED Reverse current Capacitance Detector Off-state current Capacitance Symbol VF IR CT IOFF COFF IF = 10 mA VR = 6 V V = 0, f = 1 MHz VOFF = 350 V V = 0, f = 1 MHz Test Condition Min 1.0 ⎯ ⎯ ⎯ ⎯ Typ. 1.15 ⎯ 30 ⎯ 40 Max 1.3 10 ⎯ 1 ⎯ Unit V μA pF μA pF Coupled Electrical Characteristics (Ta = 25°C) Characteristics Trigger LED current Load current limiting On-state resistance Symbol IFT ILIM RON Test Condition ION = 120 mA IF = 5 mA, VDD = 5 V, t = 5 ms ION = 120 mA, IF = 5 mA Min ⎯ 150 ⎯ Typ. 1 ⎯ 22 Max 3 300 35 Unit mA mA Ω Isolation Characteristics (Ta = 25°C) Characteristics Capacitance input to output Isolation resistance Symbol CS RS Test Condition VS = 0, f = 1 MHz VS = 500 V, R.H. ≤ 60% AC, 1 minute Isolation voltage BVS AC, 1 second (in oil) DC, 1 minute (in oil) Min ⎯ 5× 10 10 2500 ⎯ ⎯ Typ. 0.8 10 14 Max ⎯ ⎯ ⎯ ⎯ ⎯ Unit pF Ω Vrms Vdc ⎯ 5000 5000 Switching Characteristics (Ta = 25°C) Characteristics Turn-on time Turn-off time Symbol tON tOFF Test Condition RL = 200 Ω VCC = 20 V, IF = 5 mA RL = 200 Ω VCC = 20 V, IF = 5 mA (Note) (Note) Min ⎯ ⎯ Typ. ⎯ ⎯ Max 1 1 Unit ms ms Note: Switching time test circuit IF 1 4 RL VDD VOUT IF 2 3 VOUT tON 10% tOFF 90% 4 2007-10-01 TLP224G,TLP224G-2 RESTRICTIONS ON PRODUCT USE • The information contained herein is subject to change without notice. 20070701-EN • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer’s own risk. • The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. • Product names mentioned herein may be trademarks of their respective companies. • GaAs(Gallium Arsenide) is used in this product. The dust or vapor is harmful to the human body. Do not break, cut, crush or dissolve chemically. • Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations. 5 2007-10-01